If your Kenmore dryer has stopped heating, stopped tumbling or started throwing an error code, the technician you call should know the model line. The North St. Paul list starts with companies that name Kenmore, followed by other appliance repair companies that list dryer work.
This is an independent directory. We are not affiliated with Kenmore, and the technicians listed are independent repair companies, not the manufacturer.
Kenmore dryers were made for Sears by several manufacturers over the years, so the model number matters more than the badge. Independent technicians can look up the parts from it.
Kenmore Dryer Repair Near North St. Paul
We found 40 appliance repair companies within 30 miles of North St. Paul. Other nearby bases include St Paul (11), Maplewood (4), and West St Paul (4). Distances run up to about 13 miles. Nearest on the list: David Hayes Appliance Service Specialists, around 0.4 miles out. No company within 90 miles of North St. Paul mentions Kenmore by name, so these are the nearest appliance repair companies. Most work on several brands, so ask about yours. The 29 rated companies in range average 4.4 stars.
Listings come from public business data. A brand or service mention means the company names it in its listing or website; it is not a certification. Verify experience, licensing and insurance before hiring.
| Repair companies inside 30 miles | 60 |
|---|---|
| List dryer or washer & dryer work | 14 |
| Three nearest companies, miles away | 0.4, 1.4, 1.4 |
| Mention Kenmore | 0 |
| Rated 4.5 stars or higher (10+ reviews) | 23 |
| Open on Saturdays (per listing) | 48 |
Closest matches for North St. Paul: Warners' Stellian Appliance (6.3 miles away, based in Woodbury, 4.7 stars from 2,220 reviews, lists Saturday hours); Omega Force Appliance Repair (8.5 miles away, based in St Paul, 4.9 stars from 678 reviews, lists Saturday hours); Shortie's Appliances (1.9 miles away, based in Oakdale, 4.7 stars from 178 reviews, lists Saturday hours); Sears Appliance Repair (1.7 miles away, based in Maplewood, 4.5 stars from 235 reviews, lists Saturday hours).
Kenmore Dryer Lines and Features
What a Kenmore Dryer Technician Deals With
Accela Steam dryers connect directly to the household water supply, so the inlet hose and water pressure (20 to 120 psi) become part of a steam-dryer service check. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178)
On Kenmore Elite steam dryers, the display reports ductwork restriction in steps (d80, d90, d95) and a blinking CHECK VENT, which the guide says is an exhaust problem rather than a dryer failure. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178)
Kenmore Dryer Symptoms and First Checks
- Dryer takes too long to dry. Kenmore says to clean the lint filter of lint and softener residue and check the exhaust duct for buildup or excess length. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178)
- Dryer won't start. Kenmore says to confirm the cord is fully plugged into a grounded outlet and the breaker is intact, and to turn off Control Lock if buttons beep but nothing happens. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178)
What Kenmore Dryer Codes Mean
| Code | What it means |
|---|---|
| tE1-tE7 (Elite steam dryers) | A temperature sensor has failed; the dryer needs service. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178) |
| PF / nP (Elite steam dryers) | A power supply or cord connection problem; check the cord at the terminal block and the house fuse or breaker. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178) |
| gAS (Elite steam dryers) | The gas supply is off on a gas model; open the house and dryer gas shutoffs. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178) |
Kenmore Dryer Problems Worth a Service Call
- Squealing, thumping or grinding while it runs
- Dryer shuts off a few minutes into the cycle
- Drum will not turn even though you hear a hum
How a Dryer Service Call Usually Goes in North St. Paul
Care Kenmore Recommends for Its Dryers
- To clean the vent, unplug the dryer, disconnect the duct from the dryer and wall, and vacuum lint from the duct, the wall vent and the back of the dryer. Source: Kenmore - 3 Reasons to Clean Your Dryer Vent (And How to Do It)
- Clean the lint trap after every load, since lint that gets past it builds up in the vent and lengthens drying times. Source: Kenmore - 3 Reasons to Clean Your Dryer Vent (And How to Do It)
Brand guides: Kenmore Dryer Not Heating: Causes and Fixes.
Budgeting for a Kenmore Dryer Repair
Most Kenmore dryer repairs involve common parts and an hour or so of labor. For reference, published cost guides report:
- Heating element replacement: $150–$350 Source: Fixr - How much does it cost to repair a dryer?
- Control board (part only): $90–$280 Source: Angi - How Much Does Dryer Repair Cost?
- Door switch replacement: $50–$150 Source: Fixr - How much does it cost to repair a dryer?
- Drum bearing replacement: $100–$250 Source: Fixr - How much does it cost to repair a dryer?
- Service call fee (may be waived if the technician does the repair): $50–$80 per visit Source: Angi - How Much Does It Cost to Repair a Dryer?
Replacement makes more sense once a dryer is about 10 years old or past half its expected lifespan. Source: Fixr - How much does it cost to repair a dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Getting Ready for the Repair
- What happens when you press Start (no response, hum, runs with no heat, stops early)
- Whether the dryer is gas or electric
- Any error code on the display
Local Notes for North St. Paul
Most dryer calls in North St. Paul come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Minnesota has no state license for mechanical contractors or their workers; businesses contracting for gas, heating, cooling or refrigeration work file a mechanical contractor bond with the Department of Labor and Industry, and some cities require their own licenses or competency cards. Source: DLI: Mechanical contractor bond requirements
The state does not license gas fitters; contractors doing gas work must be bonded with the Department of Labor and Industry, and cities such as Minneapolis and St. Paul set their own gas fitter licensing. Source: DLI: Mechanical contractor bond requirements
Questions to Ask a North St. Paul Technician
- If a part has to be ordered, how soon can you come back to finish?
- Do you work on gas dryers, and who handles anything involving the gas line?
- What guarantee do you give on parts and labor?
Kenmore Dryer Repair FAQs: North St. Paul, MN
Why does my Kenmore dryer show an error code?
Why is my dryer running but not heating?
Is my Kenmore dryer worth repairing?
Is this Kenmore customer service?
Other Dryer Repair in North St. Paul
More Kenmore Dryer Repair Pages Nearby
Clean the lint screen, check the vent hood outside and note the model number before calling. It rules out the simple causes and speeds up a Kenmore repair.