A GE dryer shares most of its parts with other dryers, but its controls, error codes and sensor-dry cycles are specific to the brand. The Plymouth list starts with companies that name GE, followed by other appliance repair companies that list dryer work.
Washer and Dryer Repair is independent and not affiliated with GE. Listed companies are independent technicians who repair GE dryers and other brands.
GE Dryer Repair Near Plymouth
Our data shows 40 appliance repair companies inside a 30-mile radius of Plymouth. 2 list an address in Plymouth, and the rest are spread across Livonia (11), Detroit (8), and Dearborn Heights (3). The farthest listed company is about 14 miles out. The closest is Westland Appliance Repair, about 0.9 miles away. None of the companies within 30 miles mention GE by name, so we include matching companies from a longer drive plus the nearest appliance repair companies. Across 38 rated companies, the average public rating is 4.3 stars.
Listings come from public business data. A brand or service mention means the company names it in its listing or website; it is not a certification. Verify experience, licensing and insurance before hiring.
| With 4.5+ stars and at least 10 reviews | 21 |
|---|---|
| Mention GE | 0 |
| Three nearest companies, miles away | 0.9, 1.2, 3.1 |
| List dryer or washer & dryer work | 15 |
| Repair companies inside 30 miles | 60 |
| Open on Saturdays (per listing) | 38 |
The leading options for Plymouth are Sears Appliance Repair (82.7 miles away, based in Coldwater, 4.1 stars from 61 reviews, lists Saturday hours); Mr. Appliance of Oakland County (5.0 miles away, based in Livonia, 4.8 stars from 1,216 reviews, lists Saturday hours); Mr. Appliance of Dearborn Heights (9.5 miles away, based in Dearborn Heights, 4.5 stars from 233 reviews); Sears Appliance Repair (6.2 miles away, based in Livonia, 4.6 stars from 149 reviews, lists Saturday hours).
Know Your GE Dryer
How GE Dryers Are Built
An electric GE dryer receiving only partial (120V) power from its 240V circuit can tumble normally but produce no heat, and a dryer wired to a 120V circuit can take up to three times longer to dry. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
GE Dryer Symptoms and First Checks
- Check Vent alert. GE says to unplug the dryer, disconnect and vacuum the duct, and make sure the outside hood damper moves freely. Source: GE Appliances - Dryer - Check Vent Sensor Alert
- Dryer will not run or start. GE's first check is that the dryer plug is pushed fully into the wall outlet. Source: GE Appliances - Dryer - Will Not Run or Start
Reading a GE Dryer Error Code
| Code | What it means |
|---|---|
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 18 (UltraFast Combo) | The drain pump filter needs cleaning; loads may also come out wet or take longer to dry, and the drain hose should not be pushed too far into the standpipe. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
GE Dryer Problems Worth a Service Call
- Dryer shuts off a few minutes into the cycle
- Clothes still damp after a full cycle
- Drum will not turn even though you hear a hum
What Gets Fixed on a Plymouth Dryer Call
Care GE Recommends for Its Dryers
- Clean the lint filter before every load and periodically wash it in warm soapy water to remove fabric softener film. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
Brand guides: GE Dryer Not Heating: What to Check.
GE Dryer Repair Cost Ranges
Price the repair before replacing a GE dryer. Published ranges for common jobs:
- Heating element replacement: $150–$350 Source: Fixr - How much does it cost to repair a dryer?
- Control board (part only): $90–$280 Source: Angi - How Much Does Dryer Repair Cost?
- Thermal fuse repair: $80–$130 Source: Angi - How Much Does It Cost to Repair a Dryer?
- Gas valve coil replacement (gas dryer): $150–$300 Source: Fixr - How much does it cost to repair a dryer?
- Service call fee (may be waived if the technician does the repair): $50–$80 per visit Source: Angi - How Much Does It Cost to Repair a Dryer?
If a repair would cost more than about half the price of a new dryer, replacing is usually the better choice. Source: Angi - How Much Does It Cost to Repair a Dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Before the Technician Arrives
- How long the vent run is and where it exits the house
- Any error code on the display
- What happens when you press Start (no response, hum, runs with no heat, stops early)
Local Notes for Plymouth
Most dryer calls in Plymouth come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Michigan's licensing lists no separate appliance repair license; gas, heating and refrigeration service work is licensed by work classification under the state mechanical contractor license. Source: LARA: Mechanical Examination, Licensing/Registration & Application Information
In Michigan, you can check a license with the LARA Find / Verify a BCC Licensed Professional or Business or report a problem to the Michigan Department of Attorney General, Consumer Protection.
Before You Book in Plymouth
- If a part has to be ordered, how soon can you come back to finish?
- How often do you repair GE dryers, and do you carry common parts on the truck?
- Is your company licensed where my state requires it, and insured?
GE Dryer Repair FAQs: Plymouth, MI
Do you work for GE?
Why does my dryer take so long to dry?
What makes a dryer stop heating?
More Laundry Repair in Plymouth, MI
More GE Dryer Repair Pages Nearby
Clean the lint screen, check the vent hood outside and note the model number before calling. It rules out the simple causes and speeds up a GE repair.