If your GE dryer has stopped heating, stopped tumbling or started throwing an error code, the technician you call should know the model line. The Dunedin list starts with companies that name GE, followed by other appliance repair companies that list dryer work.
Independent listings only: Washer and Dryer Repair is not affiliated with or endorsed by GE. If your dryer is still under manufacturer coverage, contact GE directly.
Who Works on GE Dryers Near Dunedin
40 repair companies serve Dunedin from within 30 miles. 3 list an address in Dunedin, and other nearby bases include Clearwater (17), Palm Harbor (7), and Largo (6). None of the companies within 30 miles mention GE by name, so we include matching companies from a longer drive plus the nearest appliance repair companies. Nearest on the list: Family Appliance, around 1.3 miles out. Across 30 rated companies, the average public rating is 4.8 stars.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Open on Saturdays (per listing) | 33 |
|---|---|
| Appliance repair companies in range (30 mi) | 60 |
| Show laundry appliance work | 14 |
| With 4.5+ stars and at least 10 reviews | 31 |
| Mention GE | 0 |
| Three nearest companies, miles away | 1.3, 1.5, 2.0 |
Closest matches for Dunedin: Sears Appliance Repair (23.8 miles away, based in Temple Terrace, 4.6 stars from 131 reviews, lists Saturday hours); Mr. Appliance of Pinellas County (7.5 miles away, based in Oldsmar, 4.9 stars from 608 reviews, lists Saturday hours); Gulf Coast Appliance Repair (4.5 miles away, based in Palm Harbor, 4.8 stars from 102 reviews); Teodor Appliance Repair (9.3 miles away, based in Clearwater, 5.0 stars from 119 reviews, lists Saturday hours).
GE Dryer Lines and Features
How GE Dryers Are Built
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
An electric GE dryer receiving only partial (120V) power from its 240V circuit can tumble normally but produce no heat, and a dryer wired to a 120V circuit can take up to three times longer to dry. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
GE Dryer Symptoms and First Checks
- Dryer hot to the touch or sweating. GE says this usually means heat and humidity cannot escape, so clean the exhaust duct, clear the wall cap and confirm the elbow count suits the vent length. Source: GE Appliances - Dryer - Hot to the Touch or Sweats
- Dryer will not run or start. GE's first check is that the dryer plug is pushed fully into the wall outlet. Source: GE Appliances - Dryer - Will Not Run or Start
What GE Dryer Codes Mean
| Code | What it means |
|---|---|
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Confirm H2O Supply is ON (UltraFast Combo) | No water is entering the unit; controls lock for a few minutes while you check the water supply valves. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
When to Call for GE Dryer Repair
- Drum turns but the air stays cool
- Dryer shuts off a few minutes into the cycle
- Cycles take two or three runs to finish
Inside a Dryer Repair Visit
Care GE Recommends for Its Dryers
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
- GE does not state one maximum vent length on its support pages; it says to follow the model's installation instructions for allowed duct length and number of elbows, and recommends a 4-inch outside wall cap. Source: GE Appliances - Dryer - Things To Check For A Venting Issue
Brand guides: GE Dryer Not Heating: What to Check.
GE Dryer Repair Cost Ranges
A GE dryer repair usually costs about the same as any other brand for the same part. Published ranges:
- Control board (part only): $90–$280 Source: Angi - How Much Does Dryer Repair Cost?
- Thermostat replacement: $100–$260 Source: Fixr - How much does it cost to repair a dryer?
- Igniter replacement (gas dryer): $100–$250 Source: Fixr - How much does it cost to repair a dryer?
- Door switch replacement: $50–$150 Source: Fixr - How much does it cost to repair a dryer?
- Dryer not heating (repair by symptom): $80–$420 Source: Angi - How Much Does Dryer Repair Cost?
- Service call fee (may be waived if the technician does the repair): $50–$80 per visit Source: Angi - How Much Does It Cost to Repair a Dryer?
A dryer that keeps needing repairs despite regular maintenance is usually cheaper to replace. Source: Angi - How Much Does Dryer Repair Cost?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Before the Technician Arrives
- Any error code on the display
- How long the vent run is and where it exits the house
- What happens when you press Start (no response, hum, runs with no heat, stops early)
Local Notes for Dunedin
Most dryer calls in Dunedin come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Florida's construction licensing guidance says that paid work such as installing a dishwasher connected to drinking water or replacing a water heater requires a licensed contractor, and that a local business tax receipt or certificate of competency may also apply; it does not describe a separate state appliance repair license. Source: DBPR License Requirements and Exemptions (Construction Industry Licensing Board), posted by Columbia County
LP gas businesses are licensed by the Florida Department of Agriculture and Consumer Services; its Category V LP gas installer license covers installing and servicing LP gas appliances, piping and equipment. Source: Florida Statutes Chapter 527, Sale of Liquefied Petroleum Gas
Questions to Ask a Dunedin Technician
- What is the service call or diagnostic fee, and is it applied to the repair?
- Can you give a written estimate before ordering parts?
- If a part has to be ordered, how soon can you come back to finish?
GE Dryer Repair FAQs: Dunedin, FL
Why does my dryer take so long to dry?
Do you work for GE?
Is my GE dryer worth repairing?
Why does my GE dryer show an error code?
Other Dryer Repair in Dunedin
More GE Dryer Repair Pages Nearby
Write down any error code your GE dryer shows and when it appears. It helps a Dunedin technician bring the right parts.