Most GE dryer repairs in Lanham involve the same few systems: heat, airflow, the drum drive and the controls. The Lanham list starts with companies that name GE, followed by other appliance repair companies that list dryer work.
Independent listings only: Washer and Dryer Repair is not affiliated with or endorsed by GE. If your dryer is still under manufacturer coverage, contact GE directly.
GE Dryer Repair Near Lanham
Our data shows 40 appliance repair companies inside a 30-mile radius of Lanham. 1 list an address in Lanham, and other nearby bases include Hyattsville (4), Laurel (4), and Bowie (3). Distances run up to about 9 miles. No company within 30 miles of Lanham names GE in its listing, so the list adds matches from farther out and the closest appliance repair companies. pj appliance is the nearest, roughly 0.9 miles from Lanham. Across 37 rated companies, the average public rating is 4.2 stars.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| List dryer or washer & dryer work | 10 |
|---|---|
| Rated 4.5 stars or higher (10+ reviews) | 15 |
| Mention GE | 0 |
| Companies within 30 miles | 60 |
| Distance to the three closest (mi) | 0.9, 1.6, 2.0 |
| Listing Saturday hours | 42 |
Closest matches for Lanham: District-Columbia Hotpoint Rpr (11.5 miles away, based in Washington, 5.0 stars from 4 reviews, lists Saturday hours); Sears Appliance Repair (7.7 miles away, based in Hyattsville, 4.4 stars from 398 reviews, lists Saturday hours); Mr. Appliance of Central Maryland (4.0 miles away, based in Largo, 4.8 stars from 330 reviews); Sears Appliance Repair (6.0 miles away, based in Bowie, 4.3 stars from 426 reviews, lists Saturday hours).
GE Dryer Features Technicians Work On
What a GE Dryer Technician Deals With
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
Common GE Dryer Problems
- Dryer will not run or start. GE's first check is that the dryer plug is pushed fully into the wall outlet. Source: GE Appliances - Dryer - Will Not Run or Start
- Dryer takes too long to dry. GE points first to venting (metal duct, no kinks, clear wall cap) and a clean lint filter, then to load size, dryer level and washer spin speed. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
GE Dryer Error Codes
| Code | What it means |
|---|---|
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 18 (UltraFast Combo) | The drain pump filter needs cleaning; loads may also come out wet or take longer to dry, and the drain hose should not be pushed too far into the standpipe. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
When to Call for GE Dryer Repair
- Burning or hot smell during a cycle
- Dryer will not start when you press Start
- Drum will not turn even though you hear a hum
How a Dryer Service Call Usually Goes in Lanham
Keeping a GE Dryer Running
- GE does not state one maximum vent length on its support pages; it says to follow the model's installation instructions for allowed duct length and number of elbows, and recommends a 4-inch outside wall cap. Source: GE Appliances - Dryer - Things To Check For A Venting Issue
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
Brand guides: GE Dryer Not Heating: What to Check.
What GE Dryer Repairs Cost
A GE dryer repair usually costs about the same as any other brand for the same part. Published ranges:
- Drive motor replacement: $250–$450 Source: Fixr - How much does it cost to repair a dryer?
- Control board (part only): $90–$280 Source: Angi - How Much Does Dryer Repair Cost?
- Gas valve coil replacement (gas dryer): $150–$300 Source: Fixr - How much does it cost to repair a dryer?
- Typical dryer repair: $100–$200 Source: Fixr - How much does it cost to repair a dryer?
- Appliance technician diagnosis, washer (usually waived if hired for the repair): $50–$100 per visit Source: Fixr - How much does it cost to repair a washing machine?
Replacement makes more sense once a dryer is about 10 years old or past half its expected lifespan. Source: Fixr - How much does it cost to repair a dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Getting Ready for the Repair
- Any error code on the display
- The brand, model and serial number from the label inside the door or on the back panel
- Whether the dryer is gas or electric
Local Notes for Lanham
Most dryer calls in Lanham come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Maryland does not issue a separate appliance repair license; the Maryland Board of Plumbing licenses plumbers, natural gas fitters and propane gas fitters, whose trades cover gas connections. Source: License Requirements - Maryland Board of Plumbing (Maryland Department of Labor)
In Maryland, you can check a license with the Maryland Department of Labor occupational license search (Board of Plumbing) or report a problem to the Maryland Attorney General, Consumer Protection Division.
Before You Book in Lanham
- If a part has to be ordered, how soon can you come back to finish?
- Will you check the vent and lint path as part of the visit?
- What guarantee do you give on parts and labor?
GE Dryer Repair FAQs: Lanham, MD
Why does my GE dryer show an error code?
Why is my dryer running but not heating?
Is this GE customer service?
More Laundry Repair in Lanham, MD
GE Dryer Repair Near Lanham
Before you call, find the model and serial number on your GE dryer's label, usually inside the door opening. A technician who knows the model can often tell you on the phone what the first visit will involve.