Most GE dryer repairs in Devils Lake involve the same few systems: heat, airflow, the drum drive and the controls. We flag companies whose listing or website mentions GE and fill in with nearby dryer repair companies so you always have options.
This is an independent directory. We are not affiliated with GE, and the technicians listed are independent repair companies, not the manufacturer.
GE Dryer Repair Near Devils Lake
Our data shows 6 appliance repair companies inside a 86-mile radius of Devils Lake. 2 of them are based in Devils Lake itself, and the rest are spread across Grand Forks (3) and Jamestown (1). The farthest listed company is about 86 miles out. No company within 90 miles of Devils Lake mentions GE by name, so these are the nearest appliance repair companies. Most work on several brands, so ask about yours. Karl's TV & Appliance Devils Lake is the nearest, roughly 0.5 miles from Devils Lake. The 5 rated companies in range average 4.2 stars. Devils Lake is a smaller market, so expect a longer drive and ask whether a trip charge applies.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Show laundry appliance work | 2 |
|---|---|
| Listing Saturday hours | 5 |
| Mention GE | 0 |
| Rated 4.5 stars or higher (10+ reviews) | 2 |
| Distance to the three closest (mi) | 0.5, 0.7, 83.5 |
| Companies within 86 miles | 6 |
First up for Devils Lake: Karl's TV & Appliance Devils Lake (0.5 miles away, 4.4 stars from 30 reviews, lists Saturday hours); Brad's Appliance Repair (0.7 miles away, lists Saturday hours); Sears Appliance Repair (84.8 miles away, based in Grand Forks, 3.4 stars from 5 reviews, lists Saturday hours); Bud & Ralph's Appliance Service (83.5 miles away, based in Grand Forks, 4.6 stars from 223 reviews).
Know Your GE Dryer
How GE Dryers Are Built
The GE Profile UltraFast Combo uses a two-stage filter system (a mesh lint filter plus a second mesh or foam filter) located between the display and the dispenser drawers. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
Common GE Dryer Problems
- Dryer takes too long to dry. GE points first to venting (metal duct, no kinks, clear wall cap) and a clean lint filter, then to load size, dryer level and washer spin speed. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
- Check Vent alert. GE says to unplug the dryer, disconnect and vacuum the duct, and make sure the outside hood damper moves freely. Source: GE Appliances - Dryer - Check Vent Sensor Alert
What GE Dryer Codes Mean
| Code | What it means |
|---|---|
| 18 (UltraFast Combo) | The drain pump filter needs cleaning; loads may also come out wet or take longer to dry, and the drain hose should not be pushed too far into the standpipe. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
Signs Your GE Dryer Needs a Technician
- Dryer shuts off a few minutes into the cycle
- Squealing, thumping or grinding while it runs
- Dryer will not start when you press Start
How a Dryer Service Call Usually Goes in Devils Lake
Care GE Recommends for Its Dryers
- Inspect and clean the exhaust duct at least once a year by unplugging the dryer, disconnecting the duct and vacuuming it, and check that the outside hood flaps move freely with no nests inside. Source: GE Appliances - Dryer - How to Clean Exhaust / Vent Duct
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
Brand guides: GE Dryer Not Heating: What to Check.
GE Dryer Repair Cost Ranges
Most GE dryer repairs involve common parts and an hour or so of labor. For reference, published cost guides report:
- Thermostat replacement: $100–$260 Source: Fixr - How much does it cost to repair a dryer?
- Drum bearing replacement: $100–$250 Source: Fixr - How much does it cost to repair a dryer?
- Gas valve coil replacement (gas dryer): $150–$300 Source: Fixr - How much does it cost to repair a dryer?
- Control board (part only): $90–$280 Source: Angi - How Much Does Dryer Repair Cost?
- Service call fee (may be waived if the technician does the repair): $50–$80 per visit Source: Angi - How Much Does It Cost to Repair a Dryer?
A dryer that keeps needing repairs despite regular maintenance is usually cheaper to replace. Source: Angi - How Much Does Dryer Repair Cost?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
What to Have Ready for a GE Dryer Call
- How long the vent run is and where it exits the house
- Whether the dryer is gas or electric
- The brand, model and serial number from the label inside the door or on the back panel
Dryer Notes for Devils Lake, ND
Most dryer calls in Devils Lake come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
North Dakota's state plumbing license law covers water and drainage piping, not gas; fuel gas and mechanical licenses are issued by individual cities, with Fargo stating that a mechanical, fuel gas or dual license is needed in each jurisdiction where one works. Source: City of Fargo: Heating, Ventilation & Air Conditioning (HVAC) Exams
In North Dakota, you can check a license with the North Dakota Secretary of State FirstStop contractor search or report a problem to the North Dakota Attorney General, Consumer Protection Division.
Before You Book in Devils Lake
- Is your company licensed where my state requires it, and insured?
- Will you check the vent and lint path as part of the visit?
- Can you give a written estimate before ordering parts?
GE Dryer Repair FAQs: Devils Lake, ND
Why does my dryer take so long to dry?
How do I find a technician who knows GE dryers?
Why does my GE dryer show an error code?
Is my GE dryer worth repairing?
Other Dryer Repair in Devils Lake
GE Dryer Repair Near Devils Lake
Clean the lint screen, check the vent hood outside and note the model number before calling. It rules out the simple causes and speeds up a GE repair.