Most GE dryer repairs in Independence involve the same few systems: heat, airflow, the drum drive and the controls. The Independence list starts with companies that name GE, followed by other appliance repair companies that list dryer work.
Washer and Dryer Repair is independent and not affiliated with GE. Listed companies are independent technicians who repair GE dryers and other brands.
Independent GE Dryer Technicians, Independence OH
We found 40 appliance repair companies within 30 miles of Independence. The rest are spread across Cleveland (20), Parma (3), and North Royalton (2). The closest is Margus Appliance Repair, about 2.5 miles away. No company within 30 miles of Independence names GE in its listing, so the list adds matches from farther out and the closest appliance repair companies. The 37 rated companies in range average 4.5 stars.
Companies are shown by relevance and distance from Independence. A mention does not mean manufacturer certification, so ask each company about its experience with your dryer.
| Listing Saturday hours | 38 |
|---|---|
| With 4.5+ stars and at least 10 reviews | 26 |
| List dryer or washer & dryer work | 9 |
| Companies within 30 miles | 60 |
| Three nearest companies, miles away | 2.5, 2.7, 2.7 |
| Mention GE | 0 |
First up for Independence: Sears Appliance Repair (77.6 miles away, based in Coshocton, 4.5 stars from 28 reviews, lists Saturday hours); Sears Appliance Repair (7.7 miles away, based in Middleburg Heights, 4.7 stars from 287 reviews, lists Saturday hours); Mr. Appliance of Cleveland (4.0 miles away, based in Brooklyn Heights, 4.7 stars from 1,919 reviews, lists Saturday hours); Sears Appliance Repair (2.7 miles away, based in Seven Hills, 4.6 stars from 271 reviews, lists Saturday hours).
GE Dryer Lines and Features
What a GE Dryer Technician Deals With
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
The GE Profile UltraFast Combo uses a two-stage filter system (a mesh lint filter plus a second mesh or foam filter) located between the display and the dispenser drawers. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
What GE Says to Check First
- Dryer takes too long to dry. GE points first to venting (metal duct, no kinks, clear wall cap) and a clean lint filter, then to load size, dryer level and washer spin speed. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
- Dryer hot to the touch or sweating. GE says this usually means heat and humidity cannot escape, so clean the exhaust duct, clear the wall cap and confirm the elbow count suits the vent length. Source: GE Appliances - Dryer - Hot to the Touch or Sweats
GE Dryer Error Codes
| Code | What it means |
|---|---|
| 18 (UltraFast Combo) | The drain pump filter needs cleaning; loads may also come out wet or take longer to dry, and the drain hose should not be pushed too far into the standpipe. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
GE Dryer Problems Worth a Service Call
- Drum will not turn even though you hear a hum
- Drum turns but the air stays cool
- Cycles take two or three runs to finish
What a Dryer Repair Technician Checks
Owner Care for GE Dryers
- GE does not state one maximum vent length on its support pages; it says to follow the model's installation instructions for allowed duct length and number of elbows, and recommends a 4-inch outside wall cap. Source: GE Appliances - Dryer - Things To Check For A Venting Issue
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
Brand guides: GE Dryer Not Heating: What to Check.
GE Dryer Repair Cost Ranges
Price the repair before replacing a GE dryer. Published ranges for common jobs:
- Gas valve coil replacement (gas dryer): $150–$300 Source: Fixr - How much does it cost to repair a dryer?
- Thermal fuse repair: $80–$130 Source: Angi - How Much Does It Cost to Repair a Dryer?
- Door switch replacement: $50–$150 Source: Fixr - How much does it cost to repair a dryer?
- Typical dryer repair: $100–$200 Source: Fixr - How much does it cost to repair a dryer?
- Appliance technician diagnosis, washer (usually waived if hired for the repair): $50–$100 per visit Source: Fixr - How much does it cost to repair a washing machine?
If a repair would cost more than about half the price of a new dryer, replacing is usually the better choice. Source: Angi - How Much Does It Cost to Repair a Dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Before the Technician Arrives
- Whether the dryer is gas or electric
- Any error code on the display
- The brand, model and serial number from the label inside the door or on the back panel
What Independence Owners Should Know
Most dryer calls in Independence come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Ohio has no state license for appliance repair; the Ohio Construction Industry Licensing Board licenses commercial contractors in plumbing, hydronics, refrigeration, HVAC and electrical, and residential contractor work is generally overseen locally. Source: Ohio Department of Commerce: OCILB Contractor Complaint Form
In Ohio, you can check a license with the Ohio Department of Commerce OCILB Company Licensee Lookup or report a problem to the Ohio Attorney General, Consumer Protection Section.
How to Choose a Dryer Technician Near Independence
- What is the service call or diagnostic fee, and is it applied to the repair?
- Is your company licensed where my state requires it, and insured?
- Will you check the vent and lint path as part of the visit?
GE Dryer Repair FAQs: Independence, OH
What should I do about a GE error code?
How do I find a technician who knows GE dryers?
Do you work for GE?
Related Repair Pages for Independence
More GE Dryer Repair Pages Nearby
Before you call, find the model and serial number on your GE dryer's label, usually inside the door opening. A technician who knows the model can often tell you on the phone what the first visit will involve.