A GE dryer shares most of its parts with other dryers, but its controls, error codes and sensor-dry cycles are specific to the brand. The Belvedere list starts with companies that name GE, followed by other appliance repair companies that list dryer work.
Independent listings only: Washer and Dryer Repair is not affiliated with or endorsed by GE. If your dryer is still under manufacturer coverage, contact GE directly.
Independent GE Dryer Technicians, Belvedere SC
Within 30 miles of Belvedere there are 27 appliance repair companies in our data. The rest are spread across Augusta (16), Aiken (4), and North Augusta (2). Distances run up to about 16 miles. No company within 30 miles of Belvedere names GE in its listing, so the list adds matches from farther out and the closest appliance repair companies. Nearest on the list: Certified Appliance Repair, LLC, around 0.4 miles out. Rated companies nearby average 4.4 stars across 14 businesses.
Companies are shown by relevance and distance from Belvedere. A mention does not mean manufacturer certification, so ask each company about its experience with your dryer.
| Appliance repair companies in range (30 mi) | 27 |
|---|---|
| Mention GE | 0 |
| Distance to the three closest (mi) | 0.4, 3.0, 3.3 |
| Open on Saturdays (per listing) | 13 |
| With 4.5+ stars and at least 10 reviews | 4 |
| List dryer or washer & dryer work | 4 |
Closest matches for Belvedere: Sears Appliance Repair (87.1 miles away, based in Lugoff, 4.3 stars from 46 reviews, lists Saturday hours); Beech Island Appliance Service Co. (7.9 miles away, based in Beech Island, 4.9 stars from 159 reviews); Mr. Appliance of West Augusta (5.4 miles away, based in Augusta, 4.1 stars from 735 reviews); Sears Appliance Repair (12.5 miles away, based in Aiken, 4.4 stars from 26 reviews, lists Saturday hours).
GE Dryer Lines and Features
How GE Dryers Are Built
The GE Profile UltraFast Combo uses a two-stage filter system (a mesh lint filter plus a second mesh or foam filter) located between the display and the dispenser drawers. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
What GE Says to Check First
- Dryer will not run or start. GE's first check is that the dryer plug is pushed fully into the wall outlet. Source: GE Appliances - Dryer - Will Not Run or Start
- Gas dryer runs but does not heat. GE says to confirm a real drying cycle and temperature are selected, keep the front of the dryer unblocked, check the dedicated 120V outlet, and on new installs make sure the gas line is turned on. Source: GE Appliances - Gas Dryer - Runs But Does Not Heat
What GE Dryer Codes Mean
| Code | What it means |
|---|---|
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Confirm H2O Supply is ON (UltraFast Combo) | No water is entering the unit; controls lock for a few minutes while you check the water supply valves. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
Signs Your GE Dryer Needs a Technician
- Squealing, thumping or grinding while it runs
- Clothes still damp after a full cycle
- Dryer shuts off a few minutes into the cycle
What a Dryer Repair Technician Checks
Care GE Recommends for Its Dryers
- Clean the lint filter before every load and periodically wash it in warm soapy water to remove fabric softener film. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
- GE does not state one maximum vent length on its support pages; it says to follow the model's installation instructions for allowed duct length and number of elbows, and recommends a 4-inch outside wall cap. Source: GE Appliances - Dryer - Things To Check For A Venting Issue
Brand guides: GE Dryer Not Heating: What to Check.
GE Dryer Repair Cost Ranges
A GE dryer repair usually costs about the same as any other brand for the same part. Published ranges:
- Door switch replacement: $50–$150 Source: Fixr - How much does it cost to repair a dryer?
- Drive motor replacement: $250–$450 Source: Fixr - How much does it cost to repair a dryer?
- Heating element replacement: $150–$350 Source: Fixr - How much does it cost to repair a dryer?
- Typical dryer repair (most homeowners): $100–$430 Source: Angi - How Much Does Dryer Repair Cost?
- Technician service / diagnostic fee, dryer: $50–$80 per visit Source: Fixr - How much does it cost to repair a dryer?
If a repair would cost more than about half the price of a new dryer, replacing is usually the better choice. Source: Angi - How Much Does It Cost to Repair a Dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Before the Technician Arrives
- Whether the dryer is gas or electric
- Any error code on the display
- The brand, model and serial number from the label inside the door or on the back panel
Dryer Notes for Belvedere, SC
Most dryer calls in Belvedere come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
South Carolina does not issue a license specific to appliance repair; mechanical work such as plumbing, heating, air conditioning and refrigeration is licensed by the Contractor's Licensing Board for commercial-scale jobs and by the Residential Builders Commission for residential HVAC and plumbing. Source: S.C. Code Title 40, Chapter 11 (Contractors), South Carolina Legislature
South Carolina has no standalone gas piping license; gas lines serving gas-fired equipment are installed under mechanical classifications such as Plumbing, Heating and Packaged Equipment issued through the Department of Labor, Licensing and Regulation. Source: S.C. Code Title 40, Chapter 11 (Contractors), South Carolina Legislature
Before You Book in Belvedere
- Will you check the vent and lint path as part of the visit?
- How often do you repair GE dryers, and do you carry common parts on the truck?
- What is the service call or diagnostic fee, and is it applied to the repair?
GE Dryer Repair FAQs: Belvedere, SC
Why do my clothes come out damp?
Is my GE dryer worth repairing?
Is this GE customer service?
Related Repair Pages for Belvedere
GE Dryer Repair in Nearby Cities
Write down any error code your GE dryer shows and when it appears. It helps a Belvedere technician bring the right parts.