A GE dryer shares most of its parts with other dryers, but its controls, error codes and sensor-dry cycles are specific to the brand. Below are independent repair companies serving Santa Fe, with those that mention GE first, then the nearest dryer repair companies.
Independent listings only: Washer and Dryer Repair is not affiliated with or endorsed by GE. If your dryer is still under manufacturer coverage, contact GE directly.
Independent GE Dryer Technicians, Santa Fe TX
We found 40 appliance repair companies within 30 miles of Santa Fe. 1 of them are based in Santa Fe itself, and the rest are spread across Pasadena (11), League City (6), and Friendswood (3). Nearest on the list: A Better Deal Appliance Source, around 2.7 miles out. 1 of them mentions GE in their listing or website. The 39 rated companies in range average 4.4 stars.
Companies are shown by relevance and distance from Santa Fe. A mention does not mean manufacturer certification, so ask each company about its experience with your dryer.
| Open on Saturdays (per listing) | 45 |
|---|---|
| Distance to the three closest (mi) | 2.7, 5.5, 5.5 |
| Rated 4.5 stars or higher (10+ reviews) | 22 |
| Mention GE | 1 |
| List dryer or washer & dryer work | 20 |
| Companies within 30 miles | 60 |
Closest matches for Santa Fe: Sears Appliance Repair (8.6 miles away, based in Alvin, 4.4 stars from 84 reviews, lists Saturday hours); Sears Appliance Repair (51.2 miles away, based in Liberty, 4.7 stars from 126 reviews, lists Saturday hours); Mr. Appliance of League City (12.4 miles away, based in Friendswood, 4.8 stars from 765 reviews, lists Saturday hours); Appliance Force (10.9 miles away, based in League City, 4.9 stars from 75 reviews).
GE Dryer Features Technicians Work On
How GE Dryers Are Built
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
The GE Profile UltraFast Combo uses a two-stage filter system (a mesh lint filter plus a second mesh or foam filter) located between the display and the dispenser drawers. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
Common GE Dryer Problems
- Dryer takes too long to dry. GE points first to venting (metal duct, no kinks, clear wall cap) and a clean lint filter, then to load size, dryer level and washer spin speed. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
- Gas dryer runs but does not heat. GE says to confirm a real drying cycle and temperature are selected, keep the front of the dryer unblocked, check the dedicated 120V outlet, and on new installs make sure the gas line is turned on. Source: GE Appliances - Gas Dryer - Runs But Does Not Heat
GE Dryer Error Codes
| Code | What it means |
|---|---|
| 18 (UltraFast Combo) | The drain pump filter needs cleaning; loads may also come out wet or take longer to dry, and the drain hose should not be pushed too far into the standpipe. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Confirm H2O Supply is ON (UltraFast Combo) | No water is entering the unit; controls lock for a few minutes while you check the water supply valves. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
GE Dryer Problems Worth a Service Call
- Cycles take two or three runs to finish
- Drum will not turn even though you hear a hum
- Dryer will not start when you press Start
How a Dryer Service Call Usually Goes in Santa Fe
Owner Care for GE Dryers
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
- Clean the lint filter before every load and periodically wash it in warm soapy water to remove fabric softener film. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
Brand guides: GE Dryer Not Heating: What to Check.
GE Dryer Repair Cost Ranges
Most GE dryer repairs involve common parts and an hour or so of labor. For reference, published cost guides report:
- Gas valve coil replacement (gas dryer): $150–$300 Source: Fixr - How much does it cost to repair a dryer?
- Drive motor replacement: $250–$450 Source: Fixr - How much does it cost to repair a dryer?
- Control board (part only): $90–$280 Source: Angi - How Much Does Dryer Repair Cost?
- Technician service / diagnostic fee, dryer: $50–$80 per visit Source: Fixr - How much does it cost to repair a dryer?
A dryer that keeps needing repairs despite regular maintenance is usually cheaper to replace. Source: Angi - How Much Does Dryer Repair Cost?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Before the Technician Arrives
- What happens when you press Start (no response, hum, runs with no heat, stops early)
- How long the vent run is and where it exits the house
- The brand, model and serial number from the label inside the door or on the back panel
Dryer Notes for Santa Fe, TX
Most dryer calls in Santa Fe come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Texas has no separate appliance repair license; under the Plumbing License Law, appliance dealers and their employees may install and service appliances (other than water heaters) without a plumbing license when hooking up to existing openings with a code-approved appliance connector, while other gas or water piping work generally requires a plumbing license. Source: Plumbing License Law, Tex. Occ. Code ch. 1301, §1301.053 (Texas State Board of Plumbing Examiners)
Gas piping counts as plumbing in Texas and requires a plumbing license, with an exemption for LP gas installers who hold a separate state LP gas license. Source: Plumbing License Law, Tex. Occ. Code ch. 1301, §§1301.002, 1301.055 (Texas State Board of Plumbing Examiners)
How to Choose a Dryer Technician Near Santa Fe
- Can you give a written estimate before ordering parts?
- What guarantee do you give on parts and labor?
- Do you work on gas dryers, and who handles anything involving the gas line?
GE Dryer Repair FAQs: Santa Fe, TX
Do you work for GE?
Why is my dryer running but not heating?
Why do my clothes come out damp?
What should I do about a GE error code?
Other Dryer Repair in Santa Fe
GE Dryer Repair in Nearby Cities
Clean the lint screen, check the vent hood outside and note the model number before calling. It rules out the simple causes and speeds up a GE repair.