A GE dryer shares most of its parts with other dryers, but its controls, error codes and sensor-dry cycles are specific to the brand. The Mulvane list starts with companies that name GE, followed by other appliance repair companies that list dryer work.
This is an independent directory. We are not affiliated with GE, and the technicians listed are independent repair companies, not the manufacturer.
Who Works on GE Dryers Near Mulvane
Within 30 miles of Mulvane there are 40 appliance repair companies in our data. The rest are spread across Wichita (32), Haysville (1), and Douglass (1). None of the companies within 30 miles mention GE by name, so we include matching companies from a longer drive plus the nearest appliance repair companies. Nearest on the list: City Wide Appliance Repair Masters, around 7.4 miles out. Rated companies nearby average 4.6 stars across 19 businesses.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Rated 4.5 stars or higher (10+ reviews) | 10 |
|---|---|
| Mention GE | 0 |
| Repair companies inside 30 miles | 43 |
| Listing Saturday hours | 31 |
| Three nearest companies, miles away | 7.4, 9.4, 11.5 |
| List dryer or washer & dryer work | 5 |
Closest matches for Mulvane: Sears Appliance Repair (81.1 miles away, based in Pratt, 4.8 stars from 23 reviews, lists Saturday hours); Mr. Appliance of Wichita (21.2 miles away, based in Park City, 4.9 stars from 1,234 reviews); Appliance Nerd (14.3 miles away, based in Wichita, 4.9 stars from 56 reviews); Sears Appliance Repair (16.4 miles away, based in Wellington, 4.6 stars from 277 reviews, lists Saturday hours).
Know Your GE Dryer
How GE Dryers Are Built
An electric GE dryer receiving only partial (120V) power from its 240V circuit can tumble normally but produce no heat, and a dryer wired to a 120V circuit can take up to three times longer to dry. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
Common GE Dryer Problems
- Dryer takes too long to dry. GE points first to venting (metal duct, no kinks, clear wall cap) and a clean lint filter, then to load size, dryer level and washer spin speed. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
- Electric dryer runs but does not heat. GE says to confirm the dryer has a dedicated 240V supply, reset the breaker fully off and on, and then inspect the power cord and terminal block for burned or loose connections. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
What GE Dryer Codes Mean
| Code | What it means |
|---|---|
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 18 (UltraFast Combo) | The drain pump filter needs cleaning; loads may also come out wet or take longer to dry, and the drain hose should not be pushed too far into the standpipe. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
When to Call for GE Dryer Repair
- Clothes still damp after a full cycle
- Outside of the cabinet gets unusually hot
- Burning or hot smell during a cycle
How a Dryer Service Call Usually Goes in Mulvane
Care GE Recommends for Its Dryers
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
- GE does not state one maximum vent length on its support pages; it says to follow the model's installation instructions for allowed duct length and number of elbows, and recommends a 4-inch outside wall cap. Source: GE Appliances - Dryer - Things To Check For A Venting Issue
Brand guides: GE Dryer Not Heating: What to Check.
Budgeting for a GE Dryer Repair
A GE dryer repair usually costs about the same as any other brand for the same part. Published ranges:
- Control board (part only): $90–$280 Source: Angi - How Much Does Dryer Repair Cost?
- Thermal fuse repair: $80–$130 Source: Angi - How Much Does It Cost to Repair a Dryer?
- Drum bearing replacement: $100–$250 Source: Fixr - How much does it cost to repair a dryer?
- Drum roller replacement: $100–$150 Source: Fixr - How much does it cost to repair a dryer?
- Dryer not heating (repair by symptom): $80–$420 Source: Angi - How Much Does Dryer Repair Cost?
- Technician labor: $50–$100 per hour Source: Angi - How Much Does Dryer Repair Cost?
Replacement makes more sense once a dryer is about 10 years old or past half its expected lifespan. Source: Fixr - How much does it cost to repair a dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Before the Technician Arrives
- The brand, model and serial number from the label inside the door or on the back panel
- Any error code on the display
- What happens when you press Start (no response, hum, runs with no heat, stops early)
Local Notes for Mulvane
Most dryer calls in Mulvane come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Kansas leaves contractor and trade licensing, including plumbing and HVAC, to cities and counties, so who may do gas piping and gas appliance connections depends on the local jurisdiction. Source: Kansas Business Center: Business Starter Kit, Construction
In Kansas, you can report a problem to the Kansas Attorney General Public Protection Division (Consumer Protection).
Questions to Ask a Mulvane Technician
- What is the service call or diagnostic fee, and is it applied to the repair?
- Will you check the vent and lint path as part of the visit?
- If a part has to be ordered, how soon can you come back to finish?
GE Dryer Repair FAQs: Mulvane, KS
Why is my dryer running but not heating?
Why does my dryer take so long to dry?
How do I find a technician who knows GE dryers?
Is my GE dryer worth repairing?
More Laundry Repair in Mulvane, KS
More GE Dryer Repair Pages Nearby
Clean the lint screen, check the vent hood outside and note the model number before calling. It rules out the simple causes and speeds up a GE repair.