Most GE dryer repairs in George Mason involve the same few systems: heat, airflow, the drum drive and the controls. The George Mason list starts with companies that name GE, followed by other appliance repair companies that list dryer work.
This is an independent directory. We are not affiliated with GE, and the technicians listed are independent repair companies, not the manufacturer.
GE Dryer Repair Near George Mason
We found 40 appliance repair companies within 30 miles of George Mason. Other nearby bases include Fairfax (16), Vienna (4), and Centreville (4). Distances run up to about 6 miles. No company within 30 miles of George Mason names GE in its listing, so the list adds matches from farther out and the closest appliance repair companies. Nearest on the list: Sub-Zero Premium Repair, around 0.6 miles out. The 38 rated companies in range average 4.9 stars.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Repair companies inside 30 miles | 60 |
|---|---|
| Mention GE | 0 |
| Three nearest companies, miles away | 0.6, 0.7, 0.7 |
| Show laundry appliance work | 15 |
| Open on Saturdays (per listing) | 45 |
| Rated 4.5 stars or higher (10+ reviews) | 18 |
First up for George Mason: District-Columbia Hotpoint Rpr (15.6 miles away, based in Washington, 5.0 stars from 4 reviews, lists Saturday hours); Nova Fix Appliance (0.7 miles away, based in Fairfax, 5.0 stars from 362 reviews, lists Saturday hours); Mr. Appliance of Northern Virginia (5.3 miles away, based in Fairfax, 4.8 stars from 965 reviews, lists Saturday hours); Ace Vacuums (1.3 miles away, based in Fairfax, 4.9 stars from 996 reviews, lists Saturday hours).
GE Dryer Lines and Features
What a GE Dryer Technician Deals With
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
The GE Profile UltraFast Combo uses a two-stage filter system (a mesh lint filter plus a second mesh or foam filter) located between the display and the dispenser drawers. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
What GE Says to Check First
- Electric dryer runs but does not heat. GE says to confirm the dryer has a dedicated 240V supply, reset the breaker fully off and on, and then inspect the power cord and terminal block for burned or loose connections. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
- Gas dryer runs but does not heat. GE says to confirm a real drying cycle and temperature are selected, keep the front of the dryer unblocked, check the dedicated 120V outlet, and on new installs make sure the gas line is turned on. Source: GE Appliances - Gas Dryer - Runs But Does Not Heat
GE Dryer Error Codes
| Code | What it means |
|---|---|
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 18 (UltraFast Combo) | The drain pump filter needs cleaning; loads may also come out wet or take longer to dry, and the drain hose should not be pushed too far into the standpipe. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
When to Call for GE Dryer Repair
- Burning or hot smell during a cycle
- Drum turns but the air stays cool
- Outside of the cabinet gets unusually hot
How a Dryer Service Call Usually Goes in George Mason
Owner Care for GE Dryers
- GE does not state one maximum vent length on its support pages; it says to follow the model's installation instructions for allowed duct length and number of elbows, and recommends a 4-inch outside wall cap. Source: GE Appliances - Dryer - Things To Check For A Venting Issue
- Clean the lint filter before every load and periodically wash it in warm soapy water to remove fabric softener film. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
Brand guides: GE Dryer Not Heating: What to Check.
Budgeting for a GE Dryer Repair
Price the repair before replacing a GE dryer. Published ranges for common jobs:
- Thermostat replacement: $100–$260 Source: Fixr - How much does it cost to repair a dryer?
- Thermal fuse repair: $80–$130 Source: Angi - How Much Does It Cost to Repair a Dryer?
- Heating element replacement: $150–$350 Source: Fixr - How much does it cost to repair a dryer?
- Dryer not heating (repair by symptom): $80–$420 Source: Angi - How Much Does Dryer Repair Cost?
- Service call fee (may be waived if the technician does the repair): $50–$80 per visit Source: Angi - How Much Does It Cost to Repair a Dryer?
Replacement makes more sense once a dryer is about 10 years old or past half its expected lifespan. Source: Fixr - How much does it cost to repair a dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Getting Ready for the Repair
- Any error code on the display
- Whether the dryer is gas or electric
- What happens when you press Start (no response, hum, runs with no heat, stops early)
Dryer Notes for George Mason, VA
Most dryer calls in George Mason come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Virginia's Board for Contractors has no appliance repair license classification, but its gas fitting contracting specialty covers installing, repairing or removing gas piping and appliances attached to real property. Source: 18VAC50-22-30, Definitions of specialty services
The Board for Contractors licenses gas fitting contractors and individual gas fitter, natural gas fitter and liquefied petroleum gas fitter tradesmen. Source: 18VAC50-30-10, Definitions (Individual License and Certification Regulations)
How to Choose a Dryer Technician Near George Mason
- Is your company licensed where my state requires it, and insured?
- Will you check the vent and lint path as part of the visit?
- If a part has to be ordered, how soon can you come back to finish?
GE Dryer Repair FAQs: George Mason, VA
Why does my dryer take so long to dry?
What should I do about a GE error code?
Which George Mason technicians work on GE?
Other Dryer Repair in George Mason
More GE Dryer Repair Pages Nearby
Before you call, find the model and serial number on your GE dryer's label, usually inside the door opening. A technician who knows the model can often tell you on the phone what the first visit will involve.