A Kenmore dryer shares most of its parts with other dryers, but its controls, error codes and sensor-dry cycles are specific to the brand. Below are independent repair companies serving Taylorsville, with those that mention Kenmore first, then the nearest dryer repair companies.
This is an independent directory. We are not affiliated with Kenmore, and the technicians listed are independent repair companies, not the manufacturer.
Kenmore dryers were made for Sears by several manufacturers over the years, so the model number matters more than the badge. Independent technicians can look up the parts from it.
Independent Kenmore Dryer Technicians, Taylorsville UT
We found 40 appliance repair companies within 30 miles of Taylorsville. 4 of them are based in Taylorsville itself, and other nearby bases include West Jordan (12), West Valley City (6), and Midvale (6). Elite Taylorsville Appliance Repair is the nearest, roughly 0.5 miles from Taylorsville. No company within 90 miles of Taylorsville mentions Kenmore by name, so these are the nearest appliance repair companies. Most work on several brands, so ask about yours. Rated companies nearby average 4.6 stars across 25 businesses.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Mention Kenmore | 0 |
|---|---|
| Three nearest companies, miles away | 0.5, 0.5, 1.4 |
| Appliance repair companies in range (30 mi) | 60 |
| Listing Saturday hours | 41 |
| Show laundry appliance work | 12 |
| Rated 4.5 stars or higher (10+ reviews) | 13 |
First up for Taylorsville: PowerClean Appliance Repair (5.6 miles away, based in Midvale, 4.9 stars from 949 reviews, lists Saturday hours); Appliance Service By Paul (2.7 miles away, based in Salt Lake City, 4.8 stars from 2,590 reviews, lists Saturday hours); Mr. Appliance of Salt Lake City (3.9 miles away, based in Salt Lake City, 4.7 stars from 1,513 reviews, lists Saturday hours); Famous Appliance Service (4.5 miles away, based in Midvale, 4.6 stars from 805 reviews).
Kenmore Dryer Lines and Features
What a Kenmore Dryer Technician Deals With
On Kenmore Elite steam dryers, the display reports ductwork restriction in steps (d80, d90, d95) and a blinking CHECK VENT, which the guide says is an exhaust problem rather than a dryer failure. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178)
What Kenmore Says to Check First
- Check Vent light blinking. Kenmore says the exhaust is seriously restricted and the ducts should be cleaned and inspected before using the dryer again. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178)
- Dryer won't start. Kenmore says to confirm the cord is fully plugged into a grounded outlet and the breaker is intact, and to turn off Control Lock if buttons beep but nothing happens. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178)
What Kenmore Dryer Codes Mean
| Code | What it means |
|---|---|
| d80 / d90 / d95 (Elite steam dryers) | The exhaust ductwork is roughly 80, 90 or 95 percent blocked; stop using the dryer until the vent is cleaned or repaired. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178) |
| HS (Elite steam dryers) | The humidity (moisture) sensor has failed; the dryer needs service. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178) |
| PF / nP (Elite steam dryers) | A power supply or cord connection problem; check the cord at the terminal block and the house fuse or breaker. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178) |
Signs Your Kenmore Dryer Needs a Technician
- Cycles take two or three runs to finish
- Outside of the cabinet gets unusually hot
- Dryer shuts off a few minutes into the cycle
What a Dryer Repair Technician Checks
Care Kenmore Recommends for Its Dryers
- To clean the vent, unplug the dryer, disconnect the duct from the dryer and wall, and vacuum lint from the duct, the wall vent and the back of the dryer. Source: Kenmore - 3 Reasons to Clean Your Dryer Vent (And How to Do It)
- If the lint screen looks clogged when held to the light, scrub it with hot soapy water and a stiff brush and let it dry fully before reinstalling. Source: Kenmore - Kenmore Elite Steam Dryer Use & Care Guide (796.8178/796.9178)
Brand guides: Kenmore Dryer Not Heating: Causes and Fixes.
What Kenmore Dryer Repairs Cost
A Kenmore dryer repair usually costs about the same as any other brand for the same part. Published ranges:
- Drum roller replacement: $100–$150 Source: Fixr - How much does it cost to repair a dryer?
- Igniter replacement (gas dryer): $100–$250 Source: Fixr - How much does it cost to repair a dryer?
- Control board (part only): $90–$280 Source: Angi - How Much Does Dryer Repair Cost?
- Door switch replacement: $50–$150 Source: Fixr - How much does it cost to repair a dryer?
- Typical dryer repair: $100–$200 Source: Fixr - How much does it cost to repair a dryer?
- Appliance technician diagnosis, washer (usually waived if hired for the repair): $50–$100 per visit Source: Fixr - How much does it cost to repair a washing machine?
If a repair would cost more than about half the price of a new dryer, replacing is usually the better choice. Source: Angi - How Much Does It Cost to Repair a Dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
What to Have Ready for a Kenmore Dryer Call
- The brand, model and serial number from the label inside the door or on the back panel
- Any error code on the display
- Whether the dryer is gas or electric
Local Notes for Taylorsville
Most dryer calls in Taylorsville come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Utah has no contractor classification for appliance repair, but under the Construction Trades Licensing Act anyone who installs, repairs or replaces a residential or commercial gas appliance must hold natural gas technician certification, even on jobs otherwise too small to need a contractor license. Source: Utah Legislature H.B. 49 (2004), Natural Gas Technician Certification, amending Utah Code 58-55-305 and 58-55-308
Gas appliance and combustion system work, starting at the outlet of the gas meter, falls under DOPL's construction trades licensing, and the qualifier for an HVAC contractor license must be a Certified Natural Gas Technician. Source: DOPL Contractor Classifications
How to Choose a Dryer Technician Near Taylorsville
- What is the service call or diagnostic fee, and is it applied to the repair?
- How often do you repair Kenmore dryers, and do you carry common parts on the truck?
- If a part has to be ordered, how soon can you come back to finish?
Kenmore Dryer Repair FAQs: Taylorsville, UT
Why do my clothes come out damp?
Why is my dryer running but not heating?
What should I do about a Kenmore error code?
Should I repair or replace my Kenmore dryer?
Related Repair Pages for Taylorsville
Kenmore Dryer Repair in Nearby Cities
Clean the lint screen, check the vent hood outside and note the model number before calling. It rules out the simple causes and speeds up a Kenmore repair.