GE owners in Taylorsville usually want two things from a repair company: experience with the brand and quick access to parts. The Taylorsville list starts with companies that name GE, followed by other appliance repair companies that list dryer work.
Independent listings only: Washer and Dryer Repair is not affiliated with or endorsed by GE. If your dryer is still under manufacturer coverage, contact GE directly.
GE Dryer Repair Near Taylorsville
Within 30 miles of Taylorsville there are 40 appliance repair companies in our data. 4 list an address in Taylorsville, and other nearby bases include West Jordan (12), West Valley City (6), and Midvale (6). None of the companies within 30 miles mention GE by name, so we include matching companies from a longer drive plus the nearest appliance repair companies. Elite Taylorsville Appliance Repair is the nearest, roughly 0.5 miles from Taylorsville. Rated companies nearby average 4.6 stars across 25 businesses.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Mention GE | 0 |
|---|---|
| Listing Saturday hours | 41 |
| Rated 4.5 stars or higher (10+ reviews) | 13 |
| Appliance repair companies in range (30 mi) | 60 |
| Three nearest companies, miles away | 0.5, 0.5, 1.4 |
| Show laundry appliance work | 12 |
First up for Taylorsville: General Electric Appliance (7.7 miles away, based in Salt Lake City, 2.8 stars from 4 reviews, lists Saturday hours); Quality Appliance Service (4.5 miles away, based in West Valley City, 4.6 stars from 1,441 reviews); Eagle Appliance Repair (4.3 miles away, based in West Jordan, 4.9 stars from 204 reviews, lists Saturday hours); PowerClean Appliance Repair (5.6 miles away, based in Midvale, 4.9 stars from 949 reviews, lists Saturday hours).
Know Your GE Dryer
How GE Dryers Are Built
The GE Profile UltraFast Combo uses a two-stage filter system (a mesh lint filter plus a second mesh or foam filter) located between the display and the dispenser drawers. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
An electric GE dryer receiving only partial (120V) power from its 240V circuit can tumble normally but produce no heat, and a dryer wired to a 120V circuit can take up to three times longer to dry. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
Common GE Dryer Problems
- Electric dryer runs but does not heat. GE says to confirm the dryer has a dedicated 240V supply, reset the breaker fully off and on, and then inspect the power cord and terminal block for burned or loose connections. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
- Dryer hot to the touch or sweating. GE says this usually means heat and humidity cannot escape, so clean the exhaust duct, clear the wall cap and confirm the elbow count suits the vent length. Source: GE Appliances - Dryer - Hot to the Touch or Sweats
Reading a GE Dryer Error Code
| Code | What it means |
|---|---|
| 18 (UltraFast Combo) | The drain pump filter needs cleaning; loads may also come out wet or take longer to dry, and the drain hose should not be pushed too far into the standpipe. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Confirm H2O Supply is ON (UltraFast Combo) | No water is entering the unit; controls lock for a few minutes while you check the water supply valves. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
When to Call for GE Dryer Repair
- Clothes still damp after a full cycle
- Outside of the cabinet gets unusually hot
- Dryer shuts off a few minutes into the cycle
How a Dryer Service Call Usually Goes in Taylorsville
Keeping a GE Dryer Running
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
- Inspect and clean the exhaust duct at least once a year by unplugging the dryer, disconnecting the duct and vacuuming it, and check that the outside hood flaps move freely with no nests inside. Source: GE Appliances - Dryer - How to Clean Exhaust / Vent Duct
Brand guides: GE Dryer Not Heating: What to Check.
Budgeting for a GE Dryer Repair
A GE dryer repair usually costs about the same as any other brand for the same part. Published ranges:
- Igniter replacement (gas dryer): $100–$250 Source: Fixr - How much does it cost to repair a dryer?
- Door switch replacement: $50–$150 Source: Fixr - How much does it cost to repair a dryer?
- Drum roller replacement: $100–$150 Source: Fixr - How much does it cost to repair a dryer?
- Thermostat replacement: $100–$260 Source: Fixr - How much does it cost to repair a dryer?
- Appliance technician diagnosis, washer (usually waived if hired for the repair): $50–$100 per visit Source: Fixr - How much does it cost to repair a washing machine?
Replacement makes more sense once a dryer is about 10 years old or past half its expected lifespan. Source: Fixr - How much does it cost to repair a dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Before the Technician Arrives
- How long the vent run is and where it exits the house
- The brand, model and serial number from the label inside the door or on the back panel
- Whether the dryer is gas or electric
What Taylorsville Owners Should Know
Most dryer calls in Taylorsville come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Utah has no contractor classification for appliance repair, but under the Construction Trades Licensing Act anyone who installs, repairs or replaces a residential or commercial gas appliance must hold natural gas technician certification, even on jobs otherwise too small to need a contractor license. Source: Utah Legislature H.B. 49 (2004), Natural Gas Technician Certification, amending Utah Code 58-55-305 and 58-55-308
In Utah, you can check a license with the Utah Licensee Lookup and Verification (Verify a License) or report a problem to the Utah Department of Commerce, Division of Consumer Protection.
How to Choose a Dryer Technician Near Taylorsville
- Is your company licensed where my state requires it, and insured?
- Can you look at the washer on the same visit if it is acting up too?
- Can you give a written estimate before ordering parts?
GE Dryer Repair FAQs: Taylorsville, UT
Is this GE customer service?
Which Taylorsville technicians work on GE?
Is my GE dryer worth repairing?
Related Repair Pages for Taylorsville
GE Dryer Repair Near Taylorsville
Clean the lint screen, check the vent hood outside and note the model number before calling. It rules out the simple causes and speeds up a GE repair.