A GE dryer shares most of its parts with other dryers, but its controls, error codes and sensor-dry cycles are specific to the brand. We flag companies whose listing or website mentions GE and fill in with nearby dryer repair companies so you always have options.
This is an independent directory. We are not affiliated with GE, and the technicians listed are independent repair companies, not the manufacturer.
Who Works on GE Dryers Near Ogden
We found 27 appliance repair companies within 30 miles of Ogden. 3 of them are based in Ogden itself, and other nearby bases include Clearfield (3), North Ogden (2), and Clinton (2). Distances run up to about 29 miles. None of the companies within 30 miles mention GE by name, so we include matching companies from a longer drive plus the nearest appliance repair companies. Nearest on the list: The Appliance Whisperer's, around 0.5 miles out. Across 18 rated companies, the average public rating is 4.4 stars.
Listings come from public business data. A brand or service mention means the company names it in its listing or website; it is not a certification. Verify experience, licensing and insurance before hiring.
| Rated 4.5 stars or higher (10+ reviews) | 11 |
|---|---|
| Listing Saturday hours | 18 |
| Mention GE | 0 |
| List dryer or washer & dryer work | 0 |
| Three nearest companies, miles away | 0.5, 1.0, 3.5 |
| Appliance repair companies in range (30 mi) | 27 |
At the top of the Ogden list: General Electric Appliance (32.8 miles away, based in Salt Lake City, 2.8 stars from 4 reviews, lists Saturday hours); iFiX, LLC (4.8 miles away, based in Riverdale, 4.9 stars from 436 reviews); Ben Lomond Appliance Repair llc (6.4 miles away, based in North Ogden, 5.0 stars from 155 reviews, lists Saturday hours); Ebenezer Appliance Repair (1.0 miles away, 4.7 stars from 25 reviews).
GE Dryer Features Technicians Work On
How GE Dryers Are Built
An electric GE dryer receiving only partial (120V) power from its 240V circuit can tumble normally but produce no heat, and a dryer wired to a 120V circuit can take up to three times longer to dry. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
GE Dryer Symptoms and First Checks
- Dryer takes too long to dry. GE points first to venting (metal duct, no kinks, clear wall cap) and a clean lint filter, then to load size, dryer level and washer spin speed. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
- Gas dryer runs but does not heat. GE says to confirm a real drying cycle and temperature are selected, keep the front of the dryer unblocked, check the dedicated 120V outlet, and on new installs make sure the gas line is turned on. Source: GE Appliances - Gas Dryer - Runs But Does Not Heat
What GE Dryer Codes Mean
| Code | What it means |
|---|---|
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Confirm H2O Supply is ON (UltraFast Combo) | No water is entering the unit; controls lock for a few minutes while you check the water supply valves. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 18 (UltraFast Combo) | The drain pump filter needs cleaning; loads may also come out wet or take longer to dry, and the drain hose should not be pushed too far into the standpipe. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
When to Call for GE Dryer Repair
- Cycles take two or three runs to finish
- Dryer shuts off a few minutes into the cycle
- Drum will not turn even though you hear a hum
What a Dryer Repair Technician Checks
Care GE Recommends for Its Dryers
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
- Clean the lint filter before every load and periodically wash it in warm soapy water to remove fabric softener film. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
Brand guides: GE Dryer Not Heating: What to Check.
What GE Dryer Repairs Cost
A GE dryer repair usually costs about the same as any other brand for the same part. Published ranges:
- Heating element replacement: $150–$350 Source: Fixr - How much does it cost to repair a dryer?
- Drive motor replacement: $250–$450 Source: Fixr - How much does it cost to repair a dryer?
- Gas valve coil replacement (gas dryer): $150–$300 Source: Fixr - How much does it cost to repair a dryer?
- Thermostat replacement: $100–$260 Source: Fixr - How much does it cost to repair a dryer?
- Dryer not heating (repair by symptom): $80–$420 Source: Angi - How Much Does Dryer Repair Cost?
- Service call fee (may be waived if the technician does the repair): $50–$80 per visit Source: Angi - How Much Does It Cost to Repair a Dryer?
Replacement makes more sense once a dryer is about 10 years old or past half its expected lifespan. Source: Fixr - How much does it cost to repair a dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Getting Ready for the Repair
- What happens when you press Start (no response, hum, runs with no heat, stops early)
- The brand, model and serial number from the label inside the door or on the back panel
- Any error code on the display
What Ogden Owners Should Know
Most dryer calls in Ogden come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Utah has no contractor classification for appliance repair, but under the Construction Trades Licensing Act anyone who installs, repairs or replaces a residential or commercial gas appliance must hold natural gas technician certification, even on jobs otherwise too small to need a contractor license. Source: Utah Legislature H.B. 49 (2004), Natural Gas Technician Certification, amending Utah Code 58-55-305 and 58-55-308
In Utah, you can check a license with the Utah Licensee Lookup and Verification (Verify a License) or report a problem to the Utah Department of Commerce, Division of Consumer Protection.
Hiring a Dryer Repair Company in Ogden
- Is your company licensed where my state requires it, and insured?
- Can you look at the washer on the same visit if it is acting up too?
- Will you check the vent and lint path as part of the visit?
GE Dryer Repair FAQs: Ogden, UT
Which Ogden technicians work on GE?
What makes a dryer stop heating?
Should I repair or replace my GE dryer?
Related Repair Pages for Ogden
More GE Dryer Repair Pages Nearby
Write down any error code your GE dryer shows and when it appears. It helps a Ogden technician bring the right parts.