Most GE dryer repairs in Madison involve the same few systems: heat, airflow, the drum drive and the controls. Below are independent repair companies serving Madison, with those that mention GE first, then the nearest dryer repair companies.
Independent listings only: Washer and Dryer Repair is not affiliated with or endorsed by GE. If your dryer is still under manufacturer coverage, contact GE directly.
Independent GE Dryer Technicians, Madison AL
Our data shows 33 appliance repair companies inside a 30-mile radius of Madison. 5 list an address in Madison, and the rest are spread across Huntsville (15), Athens (4), and Hazel Green (2). The farthest listed company is about 30 miles out. The closest is Same-Day Appliance Fix in Madison, about 1.2 miles away. No company within 90 miles of Madison mentions GE by name, so these are the nearest appliance repair companies. Most work on several brands, so ask about yours. Across 27 rated companies, the average public rating is 4.4 stars.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Mention GE | 0 |
|---|---|
| With 4.5+ stars and at least 10 reviews | 8 |
| List dryer or washer & dryer work | 7 |
| Companies within 30 miles | 33 |
| Open on Saturdays (per listing) | 12 |
| Three nearest companies, miles away | 1.2, 1.4, 1.5 |
First up for Madison: Mr. Appliance of Huntsville (8.8 miles away, based in Huntsville, 4.8 stars from 1,723 reviews); Dr. Dan's Appliance Service (20.0 miles away, based in Ardmore, 4.7 stars from 213 reviews); Jay's Appliance Repair (12.1 miles away, based in Athens, 4.2 stars from 87 reviews); Sears Appliance Repair (6.0 miles away, based in Huntsville, 4.4 stars from 341 reviews, lists Saturday hours).
GE Dryer Features Technicians Work On
What a GE Dryer Technician Deals With
An electric GE dryer receiving only partial (120V) power from its 240V circuit can tumble normally but produce no heat, and a dryer wired to a 120V circuit can take up to three times longer to dry. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
GE Dryer Symptoms and First Checks
- Check Vent alert. GE says to unplug the dryer, disconnect and vacuum the duct, and make sure the outside hood damper moves freely. Source: GE Appliances - Dryer - Check Vent Sensor Alert
- Dryer will not run or start. GE's first check is that the dryer plug is pushed fully into the wall outlet. Source: GE Appliances - Dryer - Will Not Run or Start
Reading a GE Dryer Error Code
| Code | What it means |
|---|---|
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Confirm H2O Supply is ON (UltraFast Combo) | No water is entering the unit; controls lock for a few minutes while you check the water supply valves. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
Signs Your GE Dryer Needs a Technician
- Burning or hot smell during a cycle
- Drum turns but the air stays cool
- Dryer shuts off a few minutes into the cycle
Inside a Dryer Repair Visit
Owner Care for GE Dryers
- Clean the lint filter before every load and periodically wash it in warm soapy water to remove fabric softener film. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
Brand guides: GE Dryer Not Heating: What to Check.
Budgeting for a GE Dryer Repair
Most GE dryer repairs involve common parts and an hour or so of labor. For reference, published cost guides report:
- Thermal fuse repair: $80–$130 Source: Angi - How Much Does It Cost to Repair a Dryer?
- Heating element replacement: $150–$350 Source: Fixr - How much does it cost to repair a dryer?
- Drum bearing replacement: $100–$250 Source: Fixr - How much does it cost to repair a dryer?
- Drive motor replacement: $250–$450 Source: Fixr - How much does it cost to repair a dryer?
- Dryer not heating (repair by symptom): $80–$420 Source: Angi - How Much Does Dryer Repair Cost?
- Technician labor: $50–$100 per hour Source: Angi - How Much Does Dryer Repair Cost?
If a repair would cost more than about half the price of a new dryer, replacing is usually the better choice. Source: Angi - How Much Does It Cost to Repair a Dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
What to Have Ready for a GE Dryer Call
- What happens when you press Start (no response, hum, runs with no heat, stops early)
- The brand, model and serial number from the label inside the door or on the back panel
- How long the vent run is and where it exits the house
Dryer Notes for Madison, AL
Most dryer calls in Madison come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Alabama does not issue a separate appliance repair license, and the state's heating, air conditioning and refrigeration contractor law expressly excludes work on household appliances, residential refrigerators and ice machines. Source: Code of Alabama 1975, Section 34-31-18 et seq. (Alabama Board of Heating, Air Conditioning & Refrigeration Contractors)
Gas fitting work in Alabama requires a state gas fitter license from the Alabama Plumbers and Gas Fitters Examining Board, which tests competency before anyone performs, supervises or contracts gas fitting. Source: About the Board - Alabama Plumbers and Gas Fitters Examining Board
Hiring a Dryer Repair Company in Madison
- Will you check the vent and lint path as part of the visit?
- What guarantee do you give on parts and labor?
- Can you look at the washer on the same visit if it is acting up too?
GE Dryer Repair FAQs: Madison, AL
How do I find a technician who knows GE dryers?
Do you work for GE?
Is my GE dryer worth repairing?
More Laundry Repair in Madison, AL
More GE Dryer Repair Pages Nearby
Clean the lint screen, check the vent hood outside and note the model number before calling. It rules out the simple causes and speeds up a GE repair.