Most GE dryer repairs in Montrose involve the same few systems: heat, airflow, the drum drive and the controls. The Montrose list starts with companies that name GE, followed by other appliance repair companies that list dryer work.
This is an independent directory. We are not affiliated with GE, and the technicians listed are independent repair companies, not the manufacturer.
Independent GE Dryer Technicians, Montrose MN
40 repair companies serve Montrose from within 30 miles. Other nearby bases include Hopkins (5), Plymouth (4), and Wayzata (3). Distances run up to about 27 miles. The closest is Nexaro Appliance Repair Masters, about 6.7 miles away. None of the companies within 30 miles mention GE by name, so we include matching companies from a longer drive plus the nearest appliance repair companies. Across 24 rated companies, the average public rating is 4.6 stars.
Listings come from public business data. A brand or service mention means the company names it in its listing or website; it is not a certification. Verify experience, licensing and insurance before hiring.
| Mention GE | 0 |
|---|---|
| Three nearest companies, miles away | 6.7, 8.0, 12.0 |
| Open on Saturdays (per listing) | 39 |
| Show laundry appliance work | 10 |
| Appliance repair companies in range (30 mi) | 50 |
| Rated 4.5 stars or higher (10+ reviews) | 16 |
First up for Montrose: Sears Appliance Repair (54.7 miles away, based in Willmar, 4.5 stars from 37 reviews, lists Saturday hours); Omega Force Appliance Repair (19.9 miles away, based in Rogers, 4.9 stars from 1,637 reviews, lists Saturday hours); Home Appliance Service (12.0 miles away, based in Maple Lake, 5.0 stars from 230 reviews, lists Saturday hours); AMA Appliance Service (26.1 miles away, based in Hopkins, 5.0 stars from 82 reviews).
GE Dryer Features Technicians Work On
What a GE Dryer Technician Deals With
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
The GE Profile UltraFast Combo uses a two-stage filter system (a mesh lint filter plus a second mesh or foam filter) located between the display and the dispenser drawers. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
GE Dryer Symptoms and First Checks
- Electric dryer runs but does not heat. GE says to confirm the dryer has a dedicated 240V supply, reset the breaker fully off and on, and then inspect the power cord and terminal block for burned or loose connections. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
- Check Vent alert. GE says to unplug the dryer, disconnect and vacuum the duct, and make sure the outside hood damper moves freely. Source: GE Appliances - Dryer - Check Vent Sensor Alert
Reading a GE Dryer Error Code
| Code | What it means |
|---|---|
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Confirm H2O Supply is ON (UltraFast Combo) | No water is entering the unit; controls lock for a few minutes while you check the water supply valves. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
GE Dryer Problems Worth a Service Call
- Clothes still damp after a full cycle
- Dryer shuts off a few minutes into the cycle
- Drum will not turn even though you hear a hum
Inside a Dryer Repair Visit
Owner Care for GE Dryers
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
- GE does not state one maximum vent length on its support pages; it says to follow the model's installation instructions for allowed duct length and number of elbows, and recommends a 4-inch outside wall cap. Source: GE Appliances - Dryer - Things To Check For A Venting Issue
Brand guides: GE Dryer Not Heating: What to Check.
GE Dryer Repair Cost Ranges
Most GE dryer repairs involve common parts and an hour or so of labor. For reference, published cost guides report:
- Thermostat replacement: $100–$260 Source: Fixr - How much does it cost to repair a dryer?
- Door switch replacement: $50–$150 Source: Fixr - How much does it cost to repair a dryer?
- Heating element replacement: $150–$350 Source: Fixr - How much does it cost to repair a dryer?
- Dryer not heating (repair by symptom): $80–$420 Source: Angi - How Much Does Dryer Repair Cost?
- Technician labor: $50–$100 per hour Source: Angi - How Much Does Dryer Repair Cost?
If a repair would cost more than about half the price of a new dryer, replacing is usually the better choice. Source: Angi - How Much Does It Cost to Repair a Dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Getting Ready for the Repair
- What happens when you press Start (no response, hum, runs with no heat, stops early)
- Any error code on the display
- The brand, model and serial number from the label inside the door or on the back panel
Dryer Notes for Montrose, MN
Most dryer calls in Montrose come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Minnesota has no state license for mechanical contractors or their workers; businesses contracting for gas, heating, cooling or refrigeration work file a mechanical contractor bond with the Department of Labor and Industry, and some cities require their own licenses or competency cards. Source: DLI: Mechanical contractor bond requirements
In Minnesota, you can check a license with the DLI License and Registration Lookup or report a problem to the Minnesota Attorney General's Office, Consumer Assistance.
Questions to Ask a Montrose Technician
- Is your company licensed where my state requires it, and insured?
- How often do you repair GE dryers, and do you carry common parts on the truck?
- Can you look at the washer on the same visit if it is acting up too?
GE Dryer Repair FAQs: Montrose, MN
Why does my dryer take so long to dry?
Do you work for GE?
What makes a dryer stop heating?
What should I do about a GE error code?
More Laundry Repair in Montrose, MN
More GE Dryer Repair Pages Nearby
Write down any error code your GE dryer shows and when it appears. It helps a Montrose technician bring the right parts.