GE owners in Walkertown usually want two things from a repair company: experience with the brand and quick access to parts. The Walkertown list starts with companies that name GE, followed by other appliance repair companies that list dryer work.
This is an independent directory. We are not affiliated with GE, and the technicians listed are independent repair companies, not the manufacturer.
GE Dryer Repair Near Walkertown
We found 40 appliance repair companies within 30 miles of Walkertown. Other nearby bases include High Point (11), Winston-Salem (9), and Greensboro (8). The farthest listed company is about 20 miles out. Larkwell Appliance Works is the nearest, roughly 3.6 miles from Walkertown. No company within 30 miles of Walkertown names GE in its listing, so the list adds matches from farther out and the closest appliance repair companies. Across 22 rated companies, the average public rating is 4.7 stars.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Listing Saturday hours | 39 |
|---|---|
| Three nearest companies, miles away | 3.6, 3.6, 5.0 |
| Appliance repair companies in range (30 mi) | 56 |
| Rated 4.5 stars or higher (10+ reviews) | 12 |
| List dryer or washer & dryer work | 6 |
| Mention GE | 0 |
At the top of the Walkertown list: GE Appliance Services (77.9 miles away, based in Roanoke, 1.0 stars from 6 reviews, lists Saturday hours); John Michael & Associates, Inc. (14.5 miles away, based in High Point, 4.7 stars from 230 reviews); Sears Appliance Repair (14.9 miles away, based in Clemmons, 4.6 stars from 290 reviews, lists Saturday hours); Sears Appliance Repair (19.1 miles away, based in Greensboro, 4.4 stars from 955 reviews, lists Saturday hours).
GE Dryer Lines and Features
How GE Dryers Are Built
GE allows only rigid or flexible metal vent duct and says plastic flexible duct is not acceptable because it collapses, cuts airflow and can collect water. Source: GE Appliances - Dryer - Things To Check For A Venting Issue
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
Common GE Dryer Problems
- Check Vent alert. GE says to unplug the dryer, disconnect and vacuum the duct, and make sure the outside hood damper moves freely. Source: GE Appliances - Dryer - Check Vent Sensor Alert
- Dryer takes too long to dry. GE points first to venting (metal duct, no kinks, clear wall cap) and a clean lint filter, then to load size, dryer level and washer spin speed. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
Reading a GE Dryer Error Code
| Code | What it means |
|---|---|
| 18 (UltraFast Combo) | The drain pump filter needs cleaning; loads may also come out wet or take longer to dry, and the drain hose should not be pushed too far into the standpipe. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
When to Call for GE Dryer Repair
- Clothes still damp after a full cycle
- Drum turns but the air stays cool
- Dryer shuts off a few minutes into the cycle
Inside a Dryer Repair Visit
Care GE Recommends for Its Dryers
- GE does not state one maximum vent length on its support pages; it says to follow the model's installation instructions for allowed duct length and number of elbows, and recommends a 4-inch outside wall cap. Source: GE Appliances - Dryer - Things To Check For A Venting Issue
- Clean the lint filter before every load and periodically wash it in warm soapy water to remove fabric softener film. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
Brand guides: GE Dryer Not Heating: What to Check.
Budgeting for a GE Dryer Repair
A GE dryer repair usually costs about the same as any other brand for the same part. Published ranges:
- Gas valve coil replacement (gas dryer): $150–$300 Source: Fixr - How much does it cost to repair a dryer?
- Heating element replacement: $150–$350 Source: Fixr - How much does it cost to repair a dryer?
- Drum roller replacement: $100–$150 Source: Fixr - How much does it cost to repair a dryer?
- Typical dryer repair: $100–$200 Source: Fixr - How much does it cost to repair a dryer?
- Service call fee (may be waived if the technician does the repair): $50–$80 per visit Source: Angi - How Much Does It Cost to Repair a Dryer?
Replacement makes more sense once a dryer is about 10 years old or past half its expected lifespan. Source: Fixr - How much does it cost to repair a dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Before the Technician Arrives
- Whether the dryer is gas or electric
- The brand, model and serial number from the label inside the door or on the back panel
- What happens when you press Start (no response, hum, runs with no heat, stops early)
Local Notes for Walkertown
Most dryer calls in Walkertown come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
North Carolina has no license specific to appliance repair; work on gas appliances, fuel piping and heating equipment is regulated by the State Board of Examiners of Plumbing, Heating, and Fire Sprinkler Contractors, with an exemption for minor repairs that don't change fuel type, venting or piping. Source: N.C. Gen. Stat. ยง 87-21 (NC General Assembly)
In North Carolina, you can check a license with the NC Plumbing, Heating and Fire Sprinkler Board public license search or report a problem to the North Carolina Department of Justice, Consumer Protection Division.
How to Choose a Dryer Technician Near Walkertown
- If a part has to be ordered, how soon can you come back to finish?
- Is your company licensed where my state requires it, and insured?
- What guarantee do you give on parts and labor?
GE Dryer Repair FAQs: Walkertown, NC
Is my GE dryer worth repairing?
Why is my dryer running but not heating?
How do I find a technician who knows GE dryers?
Why do my clothes come out damp?
Related Repair Pages for Walkertown
More GE Dryer Repair Pages Nearby
Write down any error code your GE dryer shows and when it appears. It helps a Walkertown technician bring the right parts.