A GE dryer shares most of its parts with other dryers, but its controls, error codes and sensor-dry cycles are specific to the brand. The Red Bank list starts with companies that name GE, followed by other appliance repair companies that list dryer work.
This is an independent directory. We are not affiliated with GE, and the technicians listed are independent repair companies, not the manufacturer.
Independent GE Dryer Technicians, Red Bank TN
25 repair companies serve Red Bank from within 30 miles. Other nearby bases include Chattanooga (9), Cleveland (6), and Dalton (3). Signature Appliance Repair is the nearest, roughly 5.9 miles from Red Bank. None of the repair companies near Red Bank name GE in their listings, so we show the closest appliance repair companies. Ask each one about your model before booking. The 25 rated companies in range average 4.0 stars.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Three nearest companies, miles away | 5.9, 6.3, 6.5 |
|---|---|
| Rated 4.5 stars or higher (10+ reviews) | 10 |
| Companies within 30 miles | 25 |
| Open on Saturdays (per listing) | 15 |
| Mention GE | 0 |
| Show laundry appliance work | 9 |
At the top of the Red Bank list: Mr. Appliance of Chattanooga (6.5 miles away, based in Chattanooga, 4.7 stars from 1,103 reviews, lists Saturday hours); Masters Appliance Heating & Air (8.6 miles away, based in Chattanooga, 4.8 stars from 149 reviews); Expert Services Appliance Heating & Air LLC (13.6 miles away, based in Collegedale, 4.7 stars from 463 reviews, lists Saturday hours); Sears Appliance Repair (11.1 miles away, based in Fort Oglethorpe, 4.4 stars from 136 reviews, lists Saturday hours).
GE Dryer Lines and Features
What a GE Dryer Technician Deals With
An electric GE dryer receiving only partial (120V) power from its 240V circuit can tumble normally but produce no heat, and a dryer wired to a 120V circuit can take up to three times longer to dry. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
Common GE Dryer Problems
- Dryer takes too long to dry. GE points first to venting (metal duct, no kinks, clear wall cap) and a clean lint filter, then to load size, dryer level and washer spin speed. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
- Dryer will not run or start. GE's first check is that the dryer plug is pushed fully into the wall outlet. Source: GE Appliances - Dryer - Will Not Run or Start
GE Dryer Error Codes
| Code | What it means |
|---|---|
| Confirm H2O Supply is ON (UltraFast Combo) | No water is entering the unit; controls lock for a few minutes while you check the water supply valves. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
When to Call for GE Dryer Repair
- Drum turns but the air stays cool
- Squealing, thumping or grinding while it runs
- Dryer will not start when you press Start
What a Dryer Repair Technician Checks
Care GE Recommends for Its Dryers
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
- Clean the lint filter before every load and periodically wash it in warm soapy water to remove fabric softener film. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
Brand guides: GE Dryer Not Heating: What to Check.
Budgeting for a GE Dryer Repair
A GE dryer repair usually costs about the same as any other brand for the same part. Published ranges:
- Drum belt replacement: $150–$250 Source: Fixr - How much does it cost to repair a dryer?
- Heating element replacement: $150–$350 Source: Fixr - How much does it cost to repair a dryer?
- Igniter replacement (gas dryer): $100–$250 Source: Fixr - How much does it cost to repair a dryer?
- Typical dryer repair: $100–$200 Source: Fixr - How much does it cost to repair a dryer?
- Service call fee (may be waived if the technician does the repair): $50–$80 per visit Source: Angi - How Much Does It Cost to Repair a Dryer?
A dryer that keeps needing repairs despite regular maintenance is usually cheaper to replace. Source: Angi - How Much Does Dryer Repair Cost?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Getting Ready for the Repair
- What happens when you press Start (no response, hum, runs with no heat, stops early)
- How long the vent run is and where it exits the house
- Whether the dryer is gas or electric
What Red Bank Owners Should Know
Most dryer calls in Red Bank come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Tennessee's Board for Licensing Contractors does not list an appliance repair license among the licenses it issues (general contractor, home improvement, limited licensed electrician and limited licensed plumber). Source: TN Board for Licensing Contractors
In Tennessee, you can check a license with the Tennessee Department of Commerce and Insurance: Verify a License or report a problem to the Tennessee Division of Consumer Affairs (Office of the Attorney General).
Questions to Ask a Red Bank Technician
- Can you look at the washer on the same visit if it is acting up too?
- Can you give a written estimate before ordering parts?
- Is your company licensed where my state requires it, and insured?
GE Dryer Repair FAQs: Red Bank, TN
Should I repair or replace my GE dryer?
Do you work for GE?
Which Red Bank technicians work on GE?
More Laundry Repair in Red Bank, TN
GE Dryer Repair in Nearby Cities
Clean the lint screen, check the vent hood outside and note the model number before calling. It rules out the simple causes and speeds up a GE repair.