Most GE dryer repairs in Utica involve the same few systems: heat, airflow, the drum drive and the controls. The Utica list starts with companies that name GE, followed by other appliance repair companies that list dryer work.
This is an independent directory. We are not affiliated with GE, and the technicians listed are independent repair companies, not the manufacturer.
Independent GE Dryer Technicians, Utica MI
We found 40 appliance repair companies within 30 miles of Utica. 1 of them are based in Utica itself, and other nearby bases include Clinton Township (6), Madison Heights (4), and Warren (4). No company within 90 miles of Utica mentions GE by name, so these are the nearest appliance repair companies. Most work on several brands, so ask about yours. Nearest on the list: Doc's Appliance Service, around 0.6 miles out. Rated companies nearby average 4.2 stars across 36 businesses.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Rated 4.5 stars or higher (10+ reviews) | 23 |
|---|---|
| Show laundry appliance work | 25 |
| Appliance repair companies in range (30 mi) | 60 |
| Open on Saturdays (per listing) | 41 |
| Mention GE | 0 |
| Distance to the three closest (mi) | 0.6, 1.9, 3.0 |
First up for Utica: Sargent Appliance (5.1 miles away, based in Macomb, 4.8 stars from 1,520 reviews, lists Saturday hours); Detroit Appliance (7.9 miles away, based in Fraser, 4.8 stars from 1,139 reviews, lists Saturday hours); Sargent Appliance (7.9 miles away, based in Clinton Township, 4.8 stars from 690 reviews, lists Saturday hours); AJ's Appliance Repair & HVAC (6.5 miles away, based in Fraser, 4.6 stars from 1,181 reviews).
GE Dryer Features Technicians Work On
What a GE Dryer Technician Deals With
GE allows only rigid or flexible metal vent duct and says plastic flexible duct is not acceptable because it collapses, cuts airflow and can collect water. Source: GE Appliances - Dryer - Things To Check For A Venting Issue
An electric GE dryer receiving only partial (120V) power from its 240V circuit can tumble normally but produce no heat, and a dryer wired to a 120V circuit can take up to three times longer to dry. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
Common GE Dryer Problems
- Dryer takes too long to dry. GE points first to venting (metal duct, no kinks, clear wall cap) and a clean lint filter, then to load size, dryer level and washer spin speed. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
- Gas dryer runs but does not heat. GE says to confirm a real drying cycle and temperature are selected, keep the front of the dryer unblocked, check the dedicated 120V outlet, and on new installs make sure the gas line is turned on. Source: GE Appliances - Gas Dryer - Runs But Does Not Heat
GE Dryer Error Codes
| Code | What it means |
|---|---|
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Confirm H2O Supply is ON (UltraFast Combo) | No water is entering the unit; controls lock for a few minutes while you check the water supply valves. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
When to Call for GE Dryer Repair
- Clothes still damp after a full cycle
- Drum turns but the air stays cool
- Drum will not turn even though you hear a hum
What Gets Fixed on a Utica Dryer Call
Care GE Recommends for Its Dryers
- Inspect and clean the exhaust duct at least once a year by unplugging the dryer, disconnecting the duct and vacuuming it, and check that the outside hood flaps move freely with no nests inside. Source: GE Appliances - Dryer - How to Clean Exhaust / Vent Duct
- GE does not state one maximum vent length on its support pages; it says to follow the model's installation instructions for allowed duct length and number of elbows, and recommends a 4-inch outside wall cap. Source: GE Appliances - Dryer - Things To Check For A Venting Issue
Brand guides: GE Dryer Not Heating: What to Check.
Budgeting for a GE Dryer Repair
A GE dryer repair usually costs about the same as any other brand for the same part. Published ranges:
- Door switch replacement: $50–$150 Source: Fixr - How much does it cost to repair a dryer?
- Thermal fuse repair: $80–$130 Source: Angi - How Much Does It Cost to Repair a Dryer?
- Thermostat replacement: $100–$260 Source: Fixr - How much does it cost to repair a dryer?
- Drive motor replacement: $250–$450 Source: Fixr - How much does it cost to repair a dryer?
- Service call fee (may be waived if the technician does the repair): $50–$80 per visit Source: Angi - How Much Does It Cost to Repair a Dryer?
A dryer that keeps needing repairs despite regular maintenance is usually cheaper to replace. Source: Angi - How Much Does Dryer Repair Cost?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Getting Ready for the Repair
- How long the vent run is and where it exits the house
- Whether the dryer is gas or electric
- Any error code on the display
Dryer Notes for Utica, MI
Most dryer calls in Utica come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Michigan's licensing lists no separate appliance repair license; gas, heating and refrigeration service work is licensed by work classification under the state mechanical contractor license. Source: LARA: Mechanical Examination, Licensing/Registration & Application Information
In Michigan, you can check a license with the LARA Find / Verify a BCC Licensed Professional or Business or report a problem to the Michigan Department of Attorney General, Consumer Protection.
Before You Book in Utica
- What guarantee do you give on parts and labor?
- Will you check the vent and lint path as part of the visit?
- Can you look at the washer on the same visit if it is acting up too?
GE Dryer Repair FAQs: Utica, MI
Do you work for GE?
Is my GE dryer worth repairing?
Which Utica technicians work on GE?
Related Repair Pages for Utica
More GE Dryer Repair Pages Nearby
Before you call, find the model and serial number on your GE dryer's label, usually inside the door opening. A technician who knows the model can often tell you on the phone what the first visit will involve.