Most GE dryer repairs in Aberdeen involve the same few systems: heat, airflow, the drum drive and the controls. Below are independent repair companies serving Aberdeen, with those that mention GE first, then the nearest dryer repair companies.
Washer and Dryer Repair is independent and not affiliated with GE. Listed companies are independent technicians who repair GE dryers and other brands.
GE Dryer Repair Near Aberdeen
Within 60 miles of Aberdeen there are 14 appliance repair companies in our data. The rest are spread across Columbus (5), Booneville (2), and Steens (1). The farthest listed company is about 57 miles out. No company within 90 miles of Aberdeen mentions GE by name, so these are the nearest appliance repair companies. Most work on several brands, so ask about yours. The closest is Young Appliance, LLC, about 20.1 miles away. Across 13 rated companies, the average public rating is 4.2 stars. Because the nearest shops are farther out, ask each company whether Aberdeen is inside its regular service area.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Show laundry appliance work | 3 |
|---|---|
| Listing Saturday hours | 5 |
| Rated 4.5 stars or higher (10+ reviews) | 6 |
| Mention GE | 0 |
| Three nearest companies, miles away | 20.1, 22.0, 23.0 |
| Repair companies inside 60 miles | 14 |
The leading options for Aberdeen are Simpson Maintenance, LLC (26.0 miles away, based in Vernon, 4.9 stars from 268 reviews); Sears Appliance Repair (23.0 miles away, based in Columbus, 4.4 stars from 90 reviews, lists Saturday hours); Sears Appliance Repair (26.0 miles away, based in Columbus, 4.7 stars from 92 reviews, lists Saturday hours); Young Appliance, LLC (20.1 miles away, based in Steens, 4.9 stars from 31 reviews).
GE Dryer Lines and Features
How GE Dryers Are Built
Some GE dryers have an airflow sensor that shows a Check Vent alert when exhaust airflow drops, which usually means the vent is blocked. Source: GE Appliances - Dryer - Check Vent Sensor Alert
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
Common GE Dryer Problems
- Dryer hot to the touch or sweating. GE says this usually means heat and humidity cannot escape, so clean the exhaust duct, clear the wall cap and confirm the elbow count suits the vent length. Source: GE Appliances - Dryer - Hot to the Touch or Sweats
- Electric dryer runs but does not heat. GE says to confirm the dryer has a dedicated 240V supply, reset the breaker fully off and on, and then inspect the power cord and terminal block for burned or loose connections. Source: GE Appliances - Electric Dryer - Runs But Does Not Heat
Reading a GE Dryer Error Code
| Code | What it means |
|---|---|
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 18 (UltraFast Combo) | The drain pump filter needs cleaning; loads may also come out wet or take longer to dry, and the drain hose should not be pushed too far into the standpipe. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
Signs Your GE Dryer Needs a Technician
- Drum will not turn even though you hear a hum
- Drum turns but the air stays cool
- Squealing, thumping or grinding while it runs
How a Dryer Service Call Usually Goes in Aberdeen
Care GE Recommends for Its Dryers
- Inspect and clean the exhaust duct at least once a year by unplugging the dryer, disconnecting the duct and vacuuming it, and check that the outside hood flaps move freely with no nests inside. Source: GE Appliances - Dryer - How to Clean Exhaust / Vent Duct
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
Brand guides: GE Dryer Not Heating: What to Check.
Budgeting for a GE Dryer Repair
A GE dryer repair usually costs about the same as any other brand for the same part. Published ranges:
- Control board (part only): $90–$280 Source: Angi - How Much Does Dryer Repair Cost?
- Gas valve coil replacement (gas dryer): $150–$300 Source: Fixr - How much does it cost to repair a dryer?
- Drum belt replacement: $150–$250 Source: Fixr - How much does it cost to repair a dryer?
- Heating element replacement: $150–$350 Source: Fixr - How much does it cost to repair a dryer?
- Technician labor: $50–$100 per hour Source: Angi - How Much Does Dryer Repair Cost?
A dryer that keeps needing repairs despite regular maintenance is usually cheaper to replace. Source: Angi - How Much Does Dryer Repair Cost?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
What to Have Ready for a GE Dryer Call
- How long the vent run is and where it exits the house
- Any error code on the display
- The brand, model and serial number from the label inside the door or on the back panel
Around Aberdeen
Most dryer calls in Aberdeen come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Mississippi's State Board of Contractors has no appliance repair classification; it licenses mechanical, HVAC and plumbing contractors, with residential mechanical and plumbing subcontractors required to hold a license. Source: MSBOC: Classifications
Natural gas and liquefied petroleum gas line work falls under the State Board of Contractors' Mechanical classification, while its Plumbing classification excludes fuel gas. Source: MSBOC: Classifications
Hiring a Dryer Repair Company in Aberdeen
- Is your company licensed where my state requires it, and insured?
- Do you work on gas dryers, and who handles anything involving the gas line?
- What is the service call or diagnostic fee, and is it applied to the repair?
GE Dryer Repair FAQs: Aberdeen, MS
Is this GE customer service?
Why do my clothes come out damp?
Why does my GE dryer show an error code?
Related Repair Pages for Aberdeen
More GE Dryer Repair Pages Nearby
Write down any error code your GE dryer shows and when it appears. It helps a Aberdeen technician bring the right parts.