GE owners in Syracuse usually want two things from a repair company: experience with the brand and quick access to parts. Below are independent repair companies serving Syracuse, with those that mention GE first, then the nearest dryer repair companies.
Independent listings only: Washer and Dryer Repair is not affiliated with or endorsed by GE. If your dryer is still under manufacturer coverage, contact GE directly.
GE Dryer Repair Near Syracuse
Within 30 miles of Syracuse there are 40 appliance repair companies in our data. 1 list an address in Syracuse, and other nearby bases include Salt Lake City (15), Clearfield (3), and Ogden (3). The farthest listed company is about 26 miles out. Of those, 1 mentions GE by name. Same Hour Appliance Repair is the nearest, roughly 1.7 miles from Syracuse. The 29 rated companies in range average 4.5 stars.
Companies are shown by relevance and distance from Syracuse. A mention does not mean manufacturer certification, so ask each company about its experience with your dryer.
| Repair companies inside 30 miles | 60 |
|---|---|
| Rated 4.5 stars or higher (10+ reviews) | 20 |
| Mention GE | 1 |
| Show laundry appliance work | 4 |
| Distance to the three closest (mi) | 1.7, 3.0, 3.0 |
| Listing Saturday hours | 41 |
The leading options for Syracuse are General Electric Appliance (24.7 miles away, based in Salt Lake City, 2.8 stars from 4 reviews, lists Saturday hours); iFiX, LLC (6.4 miles away, based in Riverdale, 4.9 stars from 436 reviews); Famous Appliance Service (17.5 miles away, based in North Salt Lake, 4.7 stars from 510 reviews); Sears Home Services Appliance Repair (25.5 miles away, based in Salt Lake City, 3.8 stars from 66 reviews, lists Saturday hours).
GE Dryer Features Technicians Work On
How GE Dryers Are Built
Some GE dryers have an airflow sensor that shows a Check Vent alert when exhaust airflow drops, which usually means the vent is blocked. Source: GE Appliances - Dryer - Check Vent Sensor Alert
Sensor dry models must sit level so tumbling clothes contact the moisture sensors; an unlevel dryer can end cycles with clothes still damp. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
What GE Says to Check First
- Dryer takes too long to dry. GE points first to venting (metal duct, no kinks, clear wall cap) and a clean lint filter, then to load size, dryer level and washer spin speed. Source: GE Appliances - Dryer - Taking Too Long To Dry Clothes or Not Drying at All
- Dryer will not run or start. GE's first check is that the dryer plug is pushed fully into the wall outlet. Source: GE Appliances - Dryer - Will Not Run or Start
Reading a GE Dryer Error Code
| Code | What it means |
|---|---|
| Check and Clean Drain Pump Filter (UltraFast Combo) | A restriction, often a loose item, was detected in the drain area and the pump filter should be cleaned. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 18 (UltraFast Combo) | The drain pump filter needs cleaning; loads may also come out wet or take longer to dry, and the drain hose should not be pushed too far into the standpipe. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
| 353 (UltraFast Combo) | The lint filter is likely clogged, often with fabric softener residue; cleaning the filter clears it. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Fault & Error Codes and Status Messages |
Signs Your GE Dryer Needs a Technician
- Drum turns but the air stays cool
- Cycles take two or three runs to finish
- Drum will not turn even though you hear a hum
What a Dryer Repair Technician Checks
Care GE Recommends for Its Dryers
- On the UltraFast Combo, clean the mesh lint filter about every fifth dry cycle or when prompted, and clean the foam filter and filter compartment about every 50 cycles. Source: GE Appliances - GE Profile UltraFast Combo Washer/Dryer - Filter Cleaning
- GE does not state one maximum vent length on its support pages; it says to follow the model's installation instructions for allowed duct length and number of elbows, and recommends a 4-inch outside wall cap. Source: GE Appliances - Dryer - Things To Check For A Venting Issue
Brand guides: GE Dryer Not Heating: What to Check.
GE Dryer Repair Cost Ranges
Most GE dryer repairs involve common parts and an hour or so of labor. For reference, published cost guides report:
- Thermostat replacement: $100–$260 Source: Fixr - How much does it cost to repair a dryer?
- Drive motor replacement: $250–$450 Source: Fixr - How much does it cost to repair a dryer?
- Drum belt replacement: $150–$250 Source: Fixr - How much does it cost to repair a dryer?
- Typical dryer repair (most homeowners): $100–$430 Source: Angi - How Much Does Dryer Repair Cost?
- Service call fee (may be waived if the technician does the repair): $50–$80 per visit Source: Angi - How Much Does It Cost to Repair a Dryer?
If a repair would cost more than about half the price of a new dryer, replacing is usually the better choice. Source: Angi - How Much Does It Cost to Repair a Dryer?
Ranges are published estimates, not quotes. See the dryer repair cost guide and how long dryers last.
Before the Technician Arrives
- How long the vent run is and where it exits the house
- Whether the dryer is gas or electric
- Any error code on the display
Around Syracuse
Most dryer calls in Syracuse come down to the same handful of parts: the vent and lint path, the heat source, the belt and rollers, and the door and start switches.
Utah has no contractor classification for appliance repair, but under the Construction Trades Licensing Act anyone who installs, repairs or replaces a residential or commercial gas appliance must hold natural gas technician certification, even on jobs otherwise too small to need a contractor license. Source: Utah Legislature H.B. 49 (2004), Natural Gas Technician Certification, amending Utah Code 58-55-305 and 58-55-308
In Utah, you can check a license with the Utah Licensee Lookup and Verification (Verify a License) or report a problem to the Utah Department of Commerce, Division of Consumer Protection.
Before You Book in Syracuse
- How often do you repair GE dryers, and do you carry common parts on the truck?
- Will you check the vent and lint path as part of the visit?
- Can you give a written estimate before ordering parts?
GE Dryer Repair FAQs: Syracuse, UT
Why does my GE dryer show an error code?
What makes a dryer stop heating?
Do you work for GE?
More Laundry Repair in Syracuse, UT
More GE Dryer Repair Pages Nearby
Write down any error code your GE dryer shows and when it appears. It helps a Syracuse technician bring the right parts.